TP-Link TD-W8960N manual FCC Statement

Page 3

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

Image 3
Contents TD-W8960N Wireless N ADSL2+ Modem Router Copyright & Trademarks FCC Statement 2400.0-2483.5 MHz Country Restriction Reason/remark CE Mark WarningZhao Jianjun Director of International Business Declaration of ConformityContents Wireless Package Contents Incredible Speed Flexible Access ControlSimple Installation Overview of the RouterMain Features Panel Layout Front PanelName Status Description Back Panel Installation Environment Requirements Connecting the RouterSystem Requirements TD-W8960N Wireless N ADSL2+ Modem Router User Guide TCP/IP Configuration Quick Installation GuidePlease check the connection following these steps Failure result of Ping commandQuick Installation Guide TD-W8960N Wireless N ADSL2+ Modem Router User Guide TD-W8960N Wireless N ADSL2+ Modem Router User Guide TD-W8960N Wireless N ADSL2+ Modem Router User Guide Device Info LoginAdvanced Setup Quick SetupLayer2 Interface TD-W8960N Wireless N ADSL2+ Modem Router User Guide TD-W8960N Wireless N ADSL2+ Modem Router User Guide WAN Service ATM-EoA-PPPoE TD-W8960N Wireless N ADSL2+ Modem Router User Guide TD-W8960N Wireless N ADSL2+ Modem Router User Guide ATM-EoA-IPoE TD-W8960N Wireless N ADSL2+ Modem Router User Guide TD-W8960N Wireless N ADSL2+ Modem Router User Guide ATM-EoA-Bridge ATM-PPPoA ATM-IPoAETH-PPPoE 3 LAN ETH-IPoEETH-Bridge TD-W8960N Wireless N ADSL2+ Modem Router User Guide MAC Address Clone 5 NAT To add a virtual server entry Virtual ServersTD-W8960N Wireless N ADSL2+ Modem Router User Guide To add a new Port Triggering Port TriggeringDMZ Host Security To add a new DMZ HostIP Filtering Setup an Outgoing IP Filtering rule Setup an Incoming IP Filtering rule MAC Filtering To add a MAC Filtering rule Time Restriction Parental ControlTo add a Time Restriction entry for Parental Control rule To add a URL Filter entry for Parental Control rule URL FilterQuality of Service QoS Classification Routing Static Route Default GatewayTo remove a static routing entry To add static routing entries10 DNS 9.3 RIPDNS Server Dynamic DNS To add a Ddns entry Upnp 11 DSLInterface Grouping Dns ProxyTo create a new interface group TD-W8960N Wireless N ADSL2+ Modem Router User Guide LAN Ports IPSec Click Save/Apply to save this entry Basic WirelessWSC Setup By PBC Method Two II. By PIN TD-W8960N Wireless N ADSL2+ Modem Router User Guide WEP Manual Setup APConfigure WEP Encryption WPA WPA-PSK Configure WPA settingsWPA2 Configure WPA-PSK settingsMixed WPA2/WPA WPA2-PSKMixed WPA2/WPA-PSK MAC FilterForm of MAC Address must be xxxxxxxxxxxx, like 00130A55FF09 Wireless Bridge¾ Bridge Restrict Advanced TD-W8960N Wireless N ADSL2+ Modem Router User Guide Station info DiagnosticsManagement SettingsTo back up the Router’s current settings BackupTo update the Router’s settings UpdateTo Configure the System Log Settings System LogTo View the System Log Snmp Agent 4 TR-069 client TD-W8960N Wireless N ADSL2+ Modem Router User Guide Access Control- Passwords Internet TimeTo set the Router’s time To change the password Update SoftwareTo update the Routers software RebootWant to use NetMeeting, what do I need to do? Appendix a FAQWant to build a WEB Server on the LAN, what should I do? Wireless stations cannot connect to the Router Configure TCP/IP component Appendix B Configuring the PCTD-W8960N Wireless N ADSL2+ Modem Router User Guide ¾ Setting IP address manually Now Wireless GeneralEnvironmental and Physical Appendix D Glossary TD-W8960N Wireless N ADSL2+ Modem Router User Guide TD-W8960N Wireless N ADSL2+ Modem Router User Guide TD-W8960N Wireless N ADSL2+ Modem Router User Guide
Related manuals
Manual 122 pages 33.92 Kb