KTI Networks kgs-1601 manual Ports, Status & Settings Functions, Maximum value is

Page 17

5.2.2 Ports

On the page, you can view the Port status, set up the Speed mode and enable the FDX flow control.

Status & Settings

Functions

Link

To show the status of each port. When it is red, it means the connection is

 

down. Otherwise, it is green.

Mode

Choose the Speed mode of port 10/100/1000, Half/Full. To disable the port,

 

choose Disable. If you set to auto speed, it will be auto-negotiation.

FDX Flow Control

To Enable the FDX Flow control, click the check box.

Max Frame length

To adjust the Frame length, enter the value you need. The larger value it is,

 

the better network performance you will have. Default is 1518. The

 

Maximum value is 9600.

Apply

Click this button to save the configuration.

Refresh

Click this button to refresh the latest status of ports.

Note:

To make the maximum frame length control works properly, FDX Flow Control of the port must be enabled. The port link partner must also be enabled for supporting flow control.

-17-

Image 17
Contents Port Gigabit Ethernet Switch KGS-1601 Installation Guide Page Trademarks Table of Contents Factory Default Configuration Unpacking Information General Description Introduction to 16-port Gigabit Web Smart SwitchKey Features Front Panel Wiring for 10/100/1000Mbps CopperPort Operation LEDs DefinitionRear Panel Rear panel of the switch is shown as belowRack-mount Installation Installing 16-Port Gigabit Web Smart SwitchDesktop Installation Switch-to-Switch Connections Installing Network CablesNetwork Application Station ConnectionsFunctional Description Factory Default value Access the SwitchWeb Management guide Console Port Out-of-band connectionAggregation QoS Mirror Statistics Discovery After authentication procedure, the home page shows upHome Page System Status & Setting FunctionsAbles timeout. Timeout value in seconds, 0 Better network performance you will have. Default is 1518. Status & Settings FunctionsPorts Maximum value isVlan Entry There are 16 entries to set upTo add new Vlan Entry To remove the Vlan entryEgressTagging Settings FunctionsPort Port Number 1~16 5 QoS Aggregation/ Trunking ConfigurationTOS Value Precedence Quality of Service QoS TOS ConfigurationQoS Port Broadcast Storm QoS Port Egress Rate ControlQoS Port Ingress Rate Control Statistics MirrorAuto Search DiscoveryManual Add RemoveReboot DefaultProduct Specifications Start-up and Terminal configuration Command Line InterfaceLogin/Logout Procedures Command HierarchyHelp after a specific command Example Systemconfiguration ? You can get command information by entering ? or helpHelp Utility Prompt at top levelEntering Commands Terminology Command DescriptionMAC Address format hh-hh-hh-hh-hh-hh,hhhhhhhhhhhh or Example 00-00-24-F1-02-03System Commands Port Commands Console CommandsPort Flow Control Port ModePort State Port MaxFrameMAC Table Commands Vlan Commands Aggregation/trunking Commands QoS Commands QoS Egress Rate QoS TosprecedenceQoS Ingress Rate QoS Storm ControlIP Commands Mirror CommandsPvid ExampleFactory Default Configuration