To restore the factory-set defaults

1.Press MENU/ENTER.

2.Use the < or the > button to select Service, and then press MENU/ENTER.

3.Use the < or the > button to select Restore defaults, press MENU/ENTER, and then press MENU/ENTER again to confirm your selection.

The device automatically restarts.

Changing the device control panel display language

Use this procedure to have reports print in, and messages on the the device control panel display appear in, a language other than the default for your country/region.

Note

The Demo page prints only in English.

To change the device control panel display language

1.Press MENU/ENTER.

2.Use the < or the > button to select Common settings, and then press MENU/ENTER.

3.Use the < or the > button to select Language, and then press MENU/ENTER.

4.Use the < or the > button to select the language that you want.

5.Press MENU/ENTER to save your selection.

The device automatically restarts.

Changing the default media size

The media size should be set to the size of media that you normally load in the media input tray. The device uses this setting for copying, printing reports, printing faxes, and determining autoreduction for incoming faxes.

To change the default media size

1.Press MENU/ENTER.

2.Use the < or the > button to select Common settings, and then press MENU/ENTER.

3.Use the < or the > button to select Def. paper size, and then press MENU/ENTER.

4.Use the < or the > button until the size of paper that you have loaded appears. You can

select Letter, Legal, or A4.

5. Press MENU/ENTER to save your selection.

Using the device volume controls

You can control the volume of the following sounds:

The alarm sound that the device emits when it requires attention, such as when the device door is open.

The beeps that are emitted when you press the device control panel buttons.

16

Chapter 2 Changing the settings by using the hp toolbox or the device control panel

ENWW