HP 3020 manual Loading originals to copy, To load originals onto the flatbed scanner

Loading originals to copy

Use these instructions to load originals into your device for copying. For the best quality copies, use the flatbed scanner. See Selecting media for the automatic document feeder (ADF) for information about choosing original documents for copying.

To load originals onto the flatbed scanner

1.Make sure that the automatic document feeder (ADF) contains no media.

2.Lift the flatbed scanner cover.

3.Place the original document face-down on the flatbed scanner with the top, left corner of the document at the lower-right corner of the glass.

4.Gently close the lid.

5.The document is ready to be copied.

CAUTION	To prevent damaging the device, do not allow the scanner lid to fall onto the flatbed scanner
	surface. Always close the scanner lid when the device is not in use.

Note

To load originals into the automatic document feeder (ADF) input tray

The ADF capacity is up to 50 sheets of 75 g/m2 (20 lb) media.

The minimum size for media in the ADF is 127 by 127 mm (5 by 5 inches). For smaller sizes, use the flatbed scanner. The maximum size for media in the ADF is 216 by 381 mm (8.5 by 15 inches).

1.Make sure that the flatbed scanner contains no media.

2.Close the flatbed scanner cover and put the top end of the stack of originals into the ADF input tray, with the media stack face-up and the first page to be copied on top of the stack.

3. Slide the stack into the ADF until it does not move any farther.

48 Chapter 4 Copying ENWW