BenQ MP670 Controlling the projector through a Lan environment, If you are in a Dhcp environment

Page 45

Controlling the projector through a Lan environment

Lan Control Settings allow you to manage the projector from a computer using a web browser when the computer and the projector are properly connected to the same local area network.

Configuring the Lan Control Settings

If you are in a DHCP environment:

1.Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other end to the RJ45 port.

2.Press MENU/EXIT and then press / until the SYSTEM SETUP: Advanced menu is highlighted.

3.Press to highlight Lan Control Settings and press MODE/ENTER. The Lan Control Settings page displays.

4.Press to highlight Control By and press / to select RJ45.

Network

Network State

Disconnect

DHCP

Off

Projector IP Address

0.0.0.0

Subnet Mask

0.0.0.0

Dedault Gateway

0.0.0.0

DNS

0.0.0.0

Apply

 

MENU Back

5.Press to highlight DHCP and press / to select On.

6.Press to highlight Apply and press MODE/ENTER.

7.Re-enter the Lan Control Settings page. The Projector IP Address, Subnet Mask, Default Gateway, and DNS Server settings will display. Note down the IP address displayed in the Projector IP Address row.

If the Projector IP Address still does not display, contact your ITS administrator.

English

Operation 45

Image 45
Contents MP626/MP670 Digital Projector WelcomeTable of contents Refer servicing to qualified service personnel Important safety instructionsDo not look straight at the projector Lens during operation. The intenseEnglish Do not block the ventilation holes Ceiling mounting the projector Introduction Projector featuresShipping contents Projector exterior view Front/upper sideRear/lower side Projector Controls and functionsRemote control Timer On/Set up Remote control effective rangeSource Up/ DownReplace the tray Replacing the remote control batteryChoosing a location Positioning your projectorAspect display area Display area Obtaining a preferred projected image sizeEnglish Average MP626/670 projection dimensionsConnecting a computer Connecting a computer or monitorConnection To connect the projector to a notebook or desktop computerTo connect the projector to a monitor Connecting a monitorWith a VGA cable With a VGA to DVI-A cableConnecting Audio Connecting Video source devicesBest video quality Better video qualityTo connect the projector to an Hdmi source device Connecting Hdmi source devicesAV device Hdmi cableTo connect the projector to a Component Video source device Connecting Component Video source devicesTo connect the projector to an Audio source device Audio cableConnecting S-Video source devices To connect the projector to an S-Video source deviceVideo device Audio device To connect the projector to a composite Video source device Connecting Composite Video source devicesStarting up the projector OperationUsing a security cable lock Using the menusUse / to highlight the System Setup Basic menu Securing the projectorSetting a password Utilizing the password functionIf you forget the password Entering the password recall procedureChanging the password Disabling the password function Changing Color Space Switching input signalAdjusting the projected image Adjusting the projection angleAuto-adjusting the image Using Auto Keystone Fine-tuning the image size and clarityCorrecting keystone Keystone functionMagnifying and searching for details Selecting the aspect ratio Playing 3D functionReal About the aspect ratioSelecting a picture mode Using Wall ColorPicture modes for different types of signals Optimizing the imageSetting the User 1/User 2 mode Fine-tuning the image quality in user modesAdjusting Brightness Adjusting ContrastAdjusting Tint Adjusting ColorAdjusting Sharpness Adjusting Brilliant ColorPress MODE/ENTER and the 3D Color Management page displays 3D Color ManagementTo cancel the timer, perform the following steps Setting the presentation timerGo to the System Setup Basic Presentation Timer menu and press ModeHiding the image Remote paging operationsSetup Basic Panel Key Lock menu, and select Utilizing FAQ functionLocking control keys Freezing the imageUntil the System Setup Advanced menu To activate the High Altitude ModeTo highlight High Altitude Mode Operating in a high altitude environmentAdjusting the sound level Adjusting the soundTurning off the Power on/off ring tone Muting the soundConfiguring the Lan Control Settings Controlling the projector through a Lan environmentIf you are in a Dhcp environment If you are in a non-DHCP environment Controlling the projector remotely through a web browserPress Exit to go back to the remote network operation Press Exit to go back to the remote network operation Shutting down the projector Personalizing the projector menu display3D Color Hue Management Saturation Gain Save Settings Color T1/T2/T3/T4 Temperature Primary colorMenu operation Menu systemProjector Position Front Table/Rear Table FAQ-Image and Installation FAQ-Features and Service SourceRear Ceiling/Front Ceiling Right/Bottom-leftLamp Mode Quick Cooling Off/On High Altitude Mode Audio SettingsLamp Settings Reset All SettingsDescription of each menu DisableOff AutoDynamic Color SpaceTimer display Always Timer period 15 minTimer position Top-Left Timer counting direction Count DownPower On/Off ring tone On VolumeLamp Mode Normal Reset lamp timerPicture Mode ResolutionSource Color SystemCare of the projector MaintenanceSetting Auto Power Off Setting Lamp mode as EconomicLamp information Getting to know the lamp hourStatus Message Timing of replacing the lampReplacing the lamp Do not turn the power on with the lamp cover removedEnglish Setup Advanced Lamp Settings Resetting the lamp timerIndicators RedOff Green Troubleshooting Projector specifications SpecificationsDimensions Supported timing for PC input Timing chartResolution Horizontal Vertical Pixel Mode Supported timing for Video and S-Video inputs Supported timing for Component-YPbPr inputSXGA85 Supported timing for Hdmi Hdcp input1600 x 75.000 60.000 162.000 Limited warranty Warranty and Copyright informationCopyright DisclaimerFCC statement Regulation statementsEEC statement Weee directiveEnglish