Installation Mode
Green to Midposition
Only in case all panels have been removed and replaced by others or when the convergence is totally misaligned.
For normal convergence adjustment, this step can be skipped.
To set Green in Midposition, highlight 'Green to midposition' by pushing the control disc up or down and press ENTER to select.
A warning will be displayed :
"Are you sure to set the green motorized convergence adjustment to midposition ? This adjustment cannot be undone afterwards !".
If you are sure, press ENTER to continue, otherwise press EDIT to cancel.
Remark : While 'Green to midposition' is in progress, a clicking sound may be heard, caused by the end of adjustment motor protection.
Green Focusing
1Highlight 'Green' by pushing the Control disc up or down and press
ENTER
2Adjust the projection lens until optimal focus on position 3 is obtained.
hint : use the focusing marker lines next to the digit.
3Adjust position 1 for optimal focus.
4 Adjust position 2 for optimal focus.
5 Adjust position 3 for optimal focus.
6Repeat step 3, 4 and 5 one time as these three alignments influence each other slightly.
CONVERGENCE
GREEN TO MIDPOSITION
GREEN
BLUE ON GREEN
RED ON GREEN
HATCH
ABOUT MOCA
GREEN TO MIDPOSITION
Are you sure to set the green motorized 
convergence adjustment to midposition ? 
This adjustment cannot be undone afterwards !
<ENTER> to continue
<EXIT> to cancel
CONVERGENCE | |
GREEN TO MIDPOSITION | |
GREEN |
|
BLUE ON GREEN | |
RED ON GREEN | |
HATCH |
|
ABOUT MOCA | |
Select with | or |
then <ENTER> | |
<EXIT> to return. | |
Blue on Green convergence
1Highlight 'Blue on Green' by pushing the Control disc up or down and press ENTER to display the Blue on green test pattern.
The drawings and digits will be displayed in blue.
2Adjust position 1, 2 and 3 to obtain an optimal focus for these lines.
3 Due to interaction, it will be necessary to repeat step 2.
4Adjust position 4 and 5 for optimal convergence of the lines in 4 and 5.
5Adjust position 6 for optimal convergence of the vertical lines in 6.
6 Check if all lines are correctly converged.
CONVERGENCE | |
GREEN TO MIDPOSITION | |
GREEN |
|
BLUE ON GREEN | |
RED ON GREEN | |
HATCH |
|
ABOUT MOCA | |
Select with | or |
then <ENTER> | |
<EXIT> to return. | |
5975938 BARCOREALITY 9200TCR+ 020798 |
| |
|