3M™ Digital Projector X30N/X35N
Operating
Adjusting the projector's elevator
When the place to put the projector is slightly uneven to the left or right, use the elevator feet to place the projector horizontally.
Using the feet can also tilt the projector in order to project at |
|
a suitable angle to the screen, elevating the front side of the | 14° |
projector within 14 degrees. |
|
This projector has 2 elevator feet and 2 elevator buttons. An elevator foot is adjustable while pushing the elevator button on the same side as it.
1. Holding the projector, push the elevator buttons to release the elevator feet.
2. Position the front side of the projector to the desired height.
3. Release the elevator buttons to lock the elevator feet.
4. After making sure that the elevator feet are locked, set the projector down gently.
5. If necessary, the elevator feet can be manually twisted to make more precise adjustments. Hold the projector when twisting the feet.
1
5
To release an elevator foot, push the elevator button on the same side as it.
To finely adjust, twist the foot.
CAUTION ►Do not handle the elevator buttons without holding the projector, since the projector may drop down.
►Do not tilt the projector other than elevating its front within 14 degrees using the adjuster feet. A tilt of the projector exceeding the restriction could cause malfunction or shorten the lifetime of consumables, or the projector itself.
Adjusting the zoom and focus
1. | Use the zoom ring to adjust the screen size. | Zoom ring |
Focus ring | ||
2. | Use the focus ring to focus the picture. |
|
© 3M 2009. All Rights Reserved. | 19 |