Part names
Part names
Projector
(1)Lamp door (&62)
The lamp unit is inside.
(2)Focus ring (&19)
(3)Zoom ring (&19)
(4)Control panel (&5)
(5)Elevator buttons (x 2) (&19)
(6)Elevator feet (x 2) (&19)
(7)Remote sensor (&13)
(8)Lens (&67)
(9)Intake vents
(10)Filter cover (&64)
The air filter and intake vent are inside.
(11)Speaker (&37)
(12)Exhaust vent
(13)AC IN (AC inlet) (&12)
(14)Rear panel (&5)
(15)Security bar (&12)
(16)Security slot (&12)
(17)Slot cover (&66)
The internal clock battery is inside.
3M™ Digital Projector X30N/X35N
HOT! (1) | (2) (3) | (4) |
| |
|
|
| (11) | |
(6) |
|
| (7) | |
|
|
| ||
(9) | (8) |
| (5) | |
(10) | (6) | |||
|
| |||
(6) |
|
|
| |
|
|
| (6) |
HOT! (12) | (11) | |
(14) | ||
(4) | ||
(17) | (1) HOT! |
(15)
(13)
(16)(14)
HOT! (12)
WARNING ►HOT! : Do not touch around the lamp door and the exhaust vents during use or just after use, since it is too hot.
►Do not look into the lens or vents while the lamp is on, since the strong light is not good for your eyes.
CAUTION ►Maintain normal ventilation to prevent the projector from heating up. Do not cover, block or plug up the vents. Do not place anything that can stick or be sucked to the vents, around the intake vents. Clean the air filter periodically.
►Do not use the security bar and slot to prevent the projector from falling down, since it is not designed for it.
►Do not handle the elevator buttons without holding the projector, since the projector may drop down.
4 | © 3M 2009. All Rights Reserved. |