3M warranty IMAGEmenu, 3M Digital Projector X30N/X35N

3M™ Digital Projector X30N/X35N

IMAGE menu

IMAGE menu

From the IMAGE menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons, and press the ► cursor button or ENTER button to execute the item. Then perform it according to the following table.

Item	Description
	Using the ▲/▼ buttons switches the mode for aspect ratio.
	For a computer signal
	NORMAL ó 4:3 ó 16:9 ó 16:10
ASPECT	For a video signal, s-video signal or component video signal
	4:3 ó 16:9 ó 14:9
	For no signal
	4:3 (fixed)
	• The NORMAL mode keeps the original aspect ratio of the signal.
	Using the ◄/► buttons adjusts the over-scan ratio.
	Small (It magnifies picture) ó Large (It reduces picture)
OVER SCAN	• This item can be selected only for a video, s-video and component
	video signal.
	• When this adjustment is too large, certain degradation may appear
	at the frame area of the picture. In such a case, please adjust small.
	Using the ◄/► buttons adjusts the vertical position.
	Down ó Up
	• Over-adjusting the vertical position may cause noise to appear on
	the screen. If this occurs, please reset the vertical position to the
V POSITION	default setting. Pressing the RESET button when the V POSITION
	is selected will reset the V POSITION to the default setting.
	• When this function is performed on a video signal, s-video signal,
	or component video signal, the range of this adjustment depends
	on OVER SCAN (above) setting. It is not possible to adjust when
	OVER SCAN is set to 10.
	Using the ◄/► buttons adjusts the horizontal position.
	Left ó Right
	• Over-adjusting the horizontal position may cause noise to appear on
	the screen. If this occurs, please reset the horizontal position to the
H POSITION	default setting. Pressing the RESET button when the H POSITION is
	selected will reset the H POSITION to the default setting.
	• When this function is performed on a video signal, s-video signal,
	or component video signal, the range of this adjustment depends
	on OVER SCAN (above) setting. It is not possible to adjust when
	OVER SCAN is set to 10.

(continued on next page)

30 © 3M 2009. All Rights Reserved.