3M 3M Digital Projector X30N/X35N, Description, Communication Type, Serial Settings, Baud Rate

		3M™ Digital Projector X30N/X35N
OPTION menu
Item		Description
		COMMUNICATION TYPE
		Select the communication type for transmission via
		the CONTROL port.
		NETWORK BRIDGE ó OFF
		NETWORK BRIDGE: Select this type, if it is
		required to control an external device as a network
		terminal, via this projector from the computer.
		The CONTROL port doesn't accept RS-232C
		commands.(Controlling the external device
		via the projector (using the NETWORK BRIDGE
		function) of the Network Guide)
		OFF: Select this mode to receive RS-232C
		commands using the CONTROL port.
		• OFF is selected as the default setting.
		• When you select the NETWORK BRIDGE, check
		the item, TRANSMISSTION METHOD (below).
		SERIAL SETTINGS
		Select the serial communication condition for the
		CONTROL port.
		BAUD RATE
SERVICE	COMMUNICATION	4800bps ó 9600bps ó 19200bps ó 38400bps
(continued)	(continued)	PARITY
		NONE ó ODD ó EVEN
		• The BAUD RATE is fixed to 19200bps and PARITY
		is fixed NONE when the COMMUNICATION TYPE
		is set to OFF (above).
		TRANSMISSION METHOD
		Select the transmission method for communication by
		the NETWORK BRIDGE from the CONTROL port.
		HALF-DUPLEX ó FULL-DUPLEX
		HALF-DUPLEX: This method lets the projector
		make two way communication, but only one
		direction, either transmitting or receiving data, is
		allowed at a time.
		FULL-DUPLEX: This method lets the projector
		make two way communication, transmitting and
		receiving data at the same time.
		• HALF-DUPLEX is selected as the default setting.
		• When you select HALF-DUPLEX, check the items,
		RESPONSE LIMIT TIME and BYTES INTERVAL
		TIMEOUT (49).

(continued on next page)

48 © 3M 2009. All Rights Reserved.