3M warranty OPTION menu, 3M Digital Projector X30N/X35N

3M™ Digital Projector X30N/X35N

OPTION menu

OPTION menu

From the OPTION menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons, and press the ► cursor button or ENTER button to execute the item, except for the items LAMP TIME and FILTER TIME. Then perform it according to the following table

Item

Description

	Using the ▲/▼ buttons turns on/off the automatic signal search
	function.
	ON  OFF
AUTO SEARCH	When the ON is selected, detecting no signal automatically cycles
	through input ports in the following order. The search is started from
	the current port. Then when an input is found, the projector will stop
	searching and display the image.
	COMPUTER IN1  COMPUTER IN2
	VIDEO ï S-VIDEO ï COMPONENT (Y, Cb/Cr, Cr/Pr)
	Using the ▲/▼ buttons turns on/off the automatic keystone function.
	ON  OFF
	ON : Automatic keystone distortion correction will be executed
	whenever changing the slant of the projector.
AUTO	OFF : This function is disabled. Please execute the AUTO
KEYSTONE	KEYSTONE (EXECUTE) in the SETUP menu for automatic
	keystone distortion correction.
	• When the projector is suspended from the ceiling this feature will
	not function properly so select the OFF.
	• This function will be unavailable when the Transition Detector is on
	(59).

	Using the ▲/▼ buttons turns on/off the DIRECT ON function.
	ON  OFF
	When set to the ON, the lamp in projector will be automatically
	turned on without the usual procedure (15), only when the
DIRECT ON	projector is supplied with the power after the power was cut while
	the lamp was on.

•This function does not work as long as the power has been supplied to the projector while the lamp is off.

•After turning the lamp on by the DIRECT ON function, if neither input nor operation is detected for about 30 minutes, the projector is turned off, even though the AUTO OFF function (44) is disabled.

(continued on next page)

© 3M 2009. All Rights Reserved. 43