3M X35N Lamp warning, High Pressure, Replacing the lamp continued, High Voltage, High Temperature

3M™ Digital Projector X30N/X35N

Maintenance

Replacing the lamp (continued)

Lamp warning

HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE

WARNING ►The projector uses a high-pressure mercury glass lamp. The lamp can break with a loud bang, or burn out, if jolted or scratched, handled while hot, or worn over time. Note that each lamp has a different lifetime, and some may burst or burn out soon after you start using them. In addition, when the bulb bursts, it is possible for shards of glass to fly into the lamp housing, and for gas containing mercury to escape from the projector’s vent holes.

►About disposal of a lamp: This product contains a mercury lamp; do not put it in a trash. Dispose of it in accordance with environmental laws.

•For lamp recycling, go to www.lamprecycle.org (in the US).

•For product disposal, consult your local government agency or www.eiae.org (in the US) or www.epsc.ca (in Canada). For more information, call your dealer.

	• If the lamp should break (it will make a loud bang when it does), unplug
	the power cord from the outlet, and make sure to request a replacement
	lamp from your local dealer. Note that shards of glass could damage the
	projector’s internals, or cause injury during handling, so please do not try
	to clean the projector or replace the lamp yourself.
Disconnect • If the lamp should break (it will make a loud bang when it does), ventilate
the plug	the room well, and make sure not to breathe the gas that comes out of the
from the	projector vents, or get it in your eyes or mouth.
power	• Before replacing the lamp, turn the projector off and unplug the power
outlet	cord, then wait at least 45 minutes for the lamp to cool sufficiently.
	Handling the lamp while hot can cause burns, as well as damaging the lamp.
	• Never unscrew except the appointed (marked by an arrow) screws.
	• Do not open the lamp door while the projector is suspended from a
	ceiling. This is dangerous, since if the lamp’s bulb has broken, the shards
	will fall out when the cover is opened. In addition, working in high places is
	dangerous, so ask your local dealer to have the lamp replaced even if the
	bulb is not broken.
	• Do not use the projector with the lamp door removed. At the lamp
	replacing, make sure that the screws are screwed in firmly. Loose screws
	could result in damage or injury.
	• Use only the lamp of the specified type.
	• If the lamp breaks soon after the first time it is used, it is possible that
	there are electrical problems elsewhere besides the lamp. If this happens,
	consult your local dealer or a service representative.
	• Handle with care: jolting or scratching could cause the lamp bulb to burst during use.
	• Using the lamp for long periods of time, could cause a reduction in
	brightness, lamp failure or could cause the lamp to burst. When the
	pictures appear dark, or when the color tone is poor, please replace the
	lamp as soon as possible. Do not use old (used) lamps; this is a cause of
	breakage.
© 3M 2009. All Rights Reserved.		63