Meridian Audio D-ILA 1080MF2 operation manual

Page 1

D-ILA 1080MF2

HD D-ILA Digital Video Projector

PRELIMINARY

Installation and Operation Manual

INSTALLERS: Please review this manual carefully before contacting Technical Support.

PRODUCT OWNERS: Please contact your authorised Meridian/Faroudja dealer for product or

	installation questions.
NOTE:	The remote control supplied with this unit may differ from that shown in
	this preliminary manual.

Image 1

Contents ILA 1080MF2 FCC Information U.S.A. only About the installation placeMachine Noise Information Germany only About burning-in of the D-ILA devicePower cord Do not allow any unqualified person to install the unitDo not cut off the main plug from this equipment How To Replace The FuseStandard for gauging replacement time of components Accessories ContentsFront Side/Top Surface/Left Side Controls and FeaturesRear Side/Right Side/Bottom Surface Service Terminal Connector PanelSync OUT Terminal RS-232C Terminal D-sub 9 Pin DVI Terminal DVI-D 24 PinControl Panel Indicator Display on the Control Panel Remote Control Precautions for Using Batteries Loading Batteries into the Remote ControlOpen the back cover Load the batteriesInstallation Environment Installing the ProjectorPrecaution for Usage Adjusting the InclinationPrecautions for Ceiling-mount Projector and Screen InstallationMounting this Unit Screen Size and Projection Distance Screen Installation When reflecting off a screen Effective Range of Remote Control Unit When directing remote control unit toward this unit Connecting to Devices Connecting to Various DevicesRight Side of this unit Control from external deviceWhen using this unit, remove the lens cap Connecting the Power Cord suppliedTurning on the power Basic Operation ProceduresAdjusting zoom screen size Adjusting focusPull out the power plug from the power outlet Turning off the powerHiding the image temporarily Press HideMenu Structure Adjustments and Settings Using MenusMenu Operation Buttons Button Function This Unit Remote Control UnitPress 5/ ∞ to select a main menu item and Enter Press the Menu buttonTo confirm Image adjust Menu Menu ConfigurationSet up Menu Options MenuScreen Masking Press 5/∞ to select Set up, followed by pressingProject image onto the screen Press the Menu buttonPress 5/∞ to select Options, followed by press Ing Enter Picture Shift SettingReplacing the Lamp About Lamp ReplacementLight-source Lamp and Lamp Usage Time Pull out the lamp unit Loosen the screws on the lamp unit and lift up the handleInsert the new lamp unit until it is fully Tighten the screws of the lamp unit Close the handleInsert plug into the power outlet Resetting Lamp TimeTo ensure the lamp time has been reset ExitCleaning and Replacing the Filter Message Cause Details What to do when these messages are displayedIndicator About warning indicatorsPlease follow the procedures below Actions to be taken upon warning indicationsTroubleshooting Terminal Description Pin No Signal NamePin Arrangement RS-232C TerminalRS-232C External Control Operation mode Only Asking command is possible External control command tableSpecial parameters Specifications Front Dimensions Unit mm TopBottom SideMF2MIman v0.90ß