Meridian Audio D-ILA 1080MF2 operation manual Rear Side/Right Side/Bottom Surface

Page 8

Controls and Features (continued)

Rear Side/Right Side/Bottom Surface

Bottom Surface

Blocked as it is not in use.

Opening it forcibly will cause

damage to the unit.

qConnector Panel

For details, please refer to ‘Connector Panel’. (☞ Page 9)

wLamp Cover

Remove this cover when replacing the lamp. (☞ Page 28)

eExhaust Vent

Warm air is expelled through this vent to keep the system cool. Do not block the exhaust vents.

rRemote Sensor (Rear)

When operating with the remote control, aim it towards this sensor. (☞ Page 17)

● A remote sensor is also located at the front of the unit.

tFront Adjustable Foot (for adjusting height and angle)

It is set at the lowest position when shipped from the fac- tory.

The foot can be adjusted to a maximum angle of +6° and a maximum length of 31 mm. (☞ Page 14)

yFilter

Cleans air drawn in from the air inlet.

Please clean this filter regularly. (☞ Page 31)

uRear Fixed Foot

Image 8

Contents ILA 1080MF2 About the installation place FCC Information U.S.A. onlyMachine Noise Information Germany only About burning-in of the D-ILA deviceDo not allow any unqualified person to install the unit Power cordHow To Replace The Fuse Do not cut off the main plug from this equipmentStandard for gauging replacement time of components Contents AccessoriesControls and Features Front Side/Top Surface/Left SideRear Side/Right Side/Bottom Surface Connector Panel Service TerminalSync OUT Terminal RS-232C Terminal D-sub 9 Pin DVI Terminal DVI-D 24 PinControl Panel Indicator Display on the Control Panel Remote Control Loading Batteries into the Remote Control Precautions for Using BatteriesOpen the back cover Load the batteriesInstalling the Projector Installation EnvironmentPrecaution for Usage Adjusting the InclinationMounting this Unit Projector and Screen InstallationPrecautions for Ceiling-mount Screen Installation Screen Size and Projection Distance When directing remote control unit toward this unit Effective Range of Remote Control Unit When reflecting off a screen Connecting to Various Devices Connecting to DevicesRight Side of this unit Control from external deviceConnecting the Power Cord supplied When using this unit, remove the lens capBasic Operation Procedures Turning on the powerAdjusting zoom screen size Adjusting focusTurning off the power Pull out the power plug from the power outletHiding the image temporarily Press HideAdjustments and Settings Using Menus Menu StructureButton Function This Unit Remote Control Unit Menu Operation ButtonsTo confirm Press the Menu buttonPress 5/ ∞ to select a main menu item and Enter Menu Configuration Image adjust MenuSet up Menu Options MenuPress 5/∞ to select Set up, followed by pressing Screen MaskingProject image onto the screen Press the Menu buttonPicture Shift Setting Press 5/∞ to select Options, followed by press Ing EnterLight-source Lamp and Lamp Usage Time About Lamp ReplacementReplacing the Lamp Loosen the screws on the lamp unit and lift up the handle Pull out the lamp unitInsert the new lamp unit until it is fully Tighten the screws of the lamp unit Close the handleResetting Lamp Time Insert plug into the power outletTo ensure the lamp time has been reset ExitCleaning and Replacing the Filter What to do when these messages are displayed Message Cause Details About warning indicators IndicatorPlease follow the procedures below Actions to be taken upon warning indicationsTroubleshooting Pin No Signal Name Terminal DescriptionPin Arrangement RS-232C TerminalRS-232C External Control Special parameters External control command tableOperation mode Only Asking command is possible Specifications Dimensions Unit mm Top FrontBottom SideMF2MIman v0.90ß