Meridian Audio D-ILA 1080MF2 Connector Panel, Sync OUT Terminal RS-232C Terminal D-sub 9 Pin

Page 9

Connector Panel

1 2

SYNC	RS-232C	DVI
OUT SERVICE
CONTROL		VIDEO IN

	1 [SYNC OUT] Terminal	3 [RS-232C] Terminal (D-sub 9 Pin)
	This terminal is intended for servicing purposes. Do not	This is the RS-232C interface-specific terminal. This unit
	use it.	can be controlled by a computer connected externally.
	Using it may give rise to error or malfunction of the unit.	(☞ Page 18)
	2 [SERVICE] Terminal	● For details, please check with your authorized dealer.
	2 [SERVICE] Terminal	4 [DVI] Terminal (DVI-D 24 Pin)
	This terminal is intended for servicing purposes. Do not	4 [DVI] Terminal (DVI-D 24 Pin)
	use it.	This is an input terminal for video signals.
	Using it may give rise to error and malfunction of the unit.	Connect this to a dedicated digital video processor.
		(☞ Page 18)

Image 9

Contents ILA 1080MF2 FCC Information U.S.A. only About the installation placeMachine Noise Information Germany only About burning-in of the D-ILA devicePower cord Do not allow any unqualified person to install the unitDo not cut off the main plug from this equipment How To Replace The FuseStandard for gauging replacement time of components Accessories ContentsFront Side/Top Surface/Left Side Controls and FeaturesRear Side/Right Side/Bottom Surface Service Terminal Connector PanelSync OUT Terminal RS-232C Terminal D-sub 9 Pin DVI Terminal DVI-D 24 PinControl Panel Indicator Display on the Control Panel Remote Control Precautions for Using Batteries Loading Batteries into the Remote ControlOpen the back cover Load the batteriesInstallation Environment Installing the ProjectorPrecaution for Usage Adjusting the InclinationProjector and Screen Installation Precautions for Ceiling-mountMounting this Unit Screen Size and Projection Distance Screen InstallationEffective Range of Remote Control Unit When reflecting off a screen When directing remote control unit toward this unit Connecting to Devices Connecting to Various DevicesRight Side of this unit Control from external deviceWhen using this unit, remove the lens cap Connecting the Power Cord suppliedTurning on the power Basic Operation ProceduresAdjusting zoom screen size Adjusting focusPull out the power plug from the power outlet Turning off the powerHiding the image temporarily Press HideMenu Structure Adjustments and Settings Using MenusMenu Operation Buttons Button Function This Unit Remote Control UnitPress the Menu button Press 5/ ∞ to select a main menu item and EnterTo confirm Image adjust Menu Menu ConfigurationSet up Menu Options MenuScreen Masking Press 5/∞ to select Set up, followed by pressingProject image onto the screen Press the Menu buttonPress 5/∞ to select Options, followed by press Ing Enter Picture Shift SettingAbout Lamp Replacement Replacing the LampLight-source Lamp and Lamp Usage Time Pull out the lamp unit Loosen the screws on the lamp unit and lift up the handleInsert the new lamp unit until it is fully Tighten the screws of the lamp unit Close the handleInsert plug into the power outlet Resetting Lamp TimeTo ensure the lamp time has been reset ExitCleaning and Replacing the Filter Message Cause Details What to do when these messages are displayedIndicator About warning indicatorsPlease follow the procedures below Actions to be taken upon warning indicationsTroubleshooting Terminal Description Pin No Signal NamePin Arrangement RS-232C TerminalRS-232C External Control External control command table Operation mode Only Asking command is possibleSpecial parameters Specifications Front Dimensions Unit mm TopBottom SideMF2MIman v0.90ß

Connector Panel

1 [SYNC OUT] Terminal

3 [RS-232C] Terminal (D-sub 9 Pin)

2 [SERVICE] Terminal

4 [DVI] Terminal (DVI-D 24 Pin)