Meridian Audio D-ILA 1080MF2 operation manual MF2MIman v0.90ß

Page 40

Design and specifications are subject to change without notice. Note that some of the pictures and illustrations may have been abridged, enlarged or contextualised in order to aid comprehension. Images may differ from the actual product.

Meridian Audio Limited

Latham Road,

Huntingdon, Cambridgeshire PE29 6YE

United Kingdom

Tel +44 (0) 1480 445678

Fax +44 (0) 1480 445686

Web: www.meridian-audio.com

Faroudja is a trademark of Genesis Microchip Inc.

Other trademarks are the property of their respective owners.

Meridian America Inc

8055 Troon Circle, Suite C

Austell, Atlanta GA 30168-7849

USA

Tel +1 (404) 344 7111

Fax +1 (404) 346 7111

Email: info@meridian-audio.com

MF2MIman v0.90ß • 20060403

Image 40

Contents ILA 1080MF2 About the installation place FCC Information U.S.A. onlyMachine Noise Information Germany only About burning-in of the D-ILA deviceDo not allow any unqualified person to install the unit Power cordHow To Replace The Fuse Do not cut off the main plug from this equipmentStandard for gauging replacement time of components Contents AccessoriesControls and Features Front Side/Top Surface/Left SideRear Side/Right Side/Bottom Surface Connector Panel Service TerminalSync OUT Terminal RS-232C Terminal D-sub 9 Pin DVI Terminal DVI-D 24 PinControl Panel Indicator Display on the Control Panel Remote Control Loading Batteries into the Remote Control Precautions for Using BatteriesOpen the back cover Load the batteriesInstalling the Projector Installation EnvironmentPrecaution for Usage Adjusting the InclinationPrecautions for Ceiling-mount Projector and Screen InstallationMounting this Unit Screen Installation Screen Size and Projection Distance When reflecting off a screen Effective Range of Remote Control Unit When directing remote control unit toward this unit Connecting to Various Devices Connecting to DevicesRight Side of this unit Control from external deviceConnecting the Power Cord supplied When using this unit, remove the lens capBasic Operation Procedures Turning on the powerAdjusting zoom screen size Adjusting focusTurning off the power Pull out the power plug from the power outletHiding the image temporarily Press HideAdjustments and Settings Using Menus Menu StructureButton Function This Unit Remote Control Unit Menu Operation ButtonsPress 5/ ∞ to select a main menu item and Enter Press the Menu buttonTo confirm Menu Configuration Image adjust MenuSet up Menu Options MenuPress 5/∞ to select Set up, followed by pressing Screen MaskingProject image onto the screen Press the Menu buttonPicture Shift Setting Press 5/∞ to select Options, followed by press Ing EnterReplacing the Lamp About Lamp ReplacementLight-source Lamp and Lamp Usage Time Loosen the screws on the lamp unit and lift up the handle Pull out the lamp unitInsert the new lamp unit until it is fully Tighten the screws of the lamp unit Close the handleResetting Lamp Time Insert plug into the power outletTo ensure the lamp time has been reset ExitCleaning and Replacing the Filter What to do when these messages are displayed Message Cause Details About warning indicators IndicatorPlease follow the procedures below Actions to be taken upon warning indicationsTroubleshooting Pin No Signal Name Terminal DescriptionPin Arrangement RS-232C TerminalRS-232C External Control Operation mode Only Asking command is possible External control command tableSpecial parameters Specifications Dimensions Unit mm Top FrontBottom SideMF2MIman v0.90ß