Basic Operation Procedures
If setting for this unit is not completed, please refer to “Adjustments and Settings Using Menus”(☞ Page 22) upon turning on the power and perform the required setting accordingly. Once the basic setting is completed, this unit can be used by simply performing the following operation procedures.
STAND BY
LAMP TEMP OPERATE
MENUEXIT
ENTER
ON OPERATE OFF
FOCUS LIGHT TEST
MENUEXIT
ENTER
PRESETHIDE
‘Tele’
2
‘Wide’
‘Near’
3
‘Far’
1 Turning on the power
1Insert the power plug to the power outlet.
●The main power turns on and the [STAND BY] indicator on the unit lights up.
Light on
STAND BY
LAMP TEMP OPERATE
Indicators on this unit
2Press the [OPERATE] button on this unit (or the [OPERATE ON] button on the remote control unit) for 1 second or more
●The [OPERATE] indicator on this unit lights up and the projected im- age slowly appears.
Light on
STAND BY
LAMP TEMP OPERATE
Indicators on this unit
Notes
●Upon projection, the image may flicker for a few seconds. This is not a malfunction.
●When the light source is turned on, the lamp will slowly become brighter. It will take more than 1 minute for the brightness to stabilize.
2 Adjusting zoom (screen size)
To enlarge the screen size
Turn the zoom ring towards the ‘Wide’ side.
To reduce the screen size
Turn the zoom ring towards the ‘Tele’ side.
3 Adjusting focus
To focus on nearer points
Turn the focus ring towards the ‘Near’ side.
To focus on farther points
Turn the focus ring towards the ‘Far’ side.
20