Meridian Audio D-ILA 1080MF2 operation manual Effective Range of Remote Control Unit

Page 17

Effective Range of Remote Control Unit

The operable distance of the remote control unit is about 7 m for direct reception. The remote control unit can be used by having the transmission signal reflected off a screen.

●If the fluorescent lamp is lit, the remote control unit might not function properly.

When reflecting off a screen

Ensure that total of distance A between this unit and screen and distance B between remote control and screen is within 7 m.

●As the effect of signals reflected from the remote control unit differ with the type of screen used, operable distance may decrease.

Screen

30˚

30˚

Remote Sensor (Rear)

	20˚	This unit
	20˚	A
	20˚	A
	20˚
	B

Remote Control Unit

When directing remote control unit toward this unit

When aiming the remote control unit towards the remote sensor on this unit, ensure that the distance to the sensor in front or at the rear of this unit is within 7 m.

● If the remote control fails to work properly, move closer to this unit.

This unit

30˚

30˚

20˚

20˚

Remote Control Unit

17

Image 17

Contents ILA 1080MF2 FCC Information U.S.A. only About the installation placeMachine Noise Information Germany only About burning-in of the D-ILA devicePower cord Do not allow any unqualified person to install the unitDo not cut off the main plug from this equipment How To Replace The FuseStandard for gauging replacement time of components Accessories ContentsFront Side/Top Surface/Left Side Controls and FeaturesRear Side/Right Side/Bottom Surface Service Terminal Connector PanelSync OUT Terminal RS-232C Terminal D-sub 9 Pin DVI Terminal DVI-D 24 PinControl Panel Indicator Display on the Control Panel Remote Control Precautions for Using Batteries Loading Batteries into the Remote ControlOpen the back cover Load the batteries Installation Environment Installing the Projector Precaution for Usage Adjusting the InclinationMounting this Unit Projector and Screen InstallationPrecautions for Ceiling-mount Screen Size and Projection Distance Screen Installation When directing remote control unit toward this unit Effective Range of Remote Control Unit When reflecting off a screen Connecting to Devices Connecting to Various DevicesRight Side of this unit Control from external deviceWhen using this unit, remove the lens cap Connecting the Power Cord suppliedTurning on the power Basic Operation ProceduresAdjusting zoom screen size Adjusting focusPull out the power plug from the power outlet Turning off the powerHiding the image temporarily Press HideMenu Structure Adjustments and Settings Using MenusMenu Operation Buttons Button Function This Unit Remote Control UnitTo confirm Press the Menu buttonPress 5/ ∞ to select a main menu item and Enter Image adjust Menu Menu ConfigurationSet up Menu Options MenuScreen Masking Press 5/∞ to select Set up, followed by pressingProject image onto the screen Press the Menu buttonPress 5/∞ to select Options, followed by press Ing Enter Picture Shift SettingLight-source Lamp and Lamp Usage Time About Lamp ReplacementReplacing the Lamp Pull out the lamp unit Loosen the screws on the lamp unit and lift up the handleInsert the new lamp unit until it is fully Tighten the screws of the lamp unit Close the handleInsert plug into the power outlet Resetting Lamp TimeTo ensure the lamp time has been reset ExitCleaning and Replacing the Filter Message Cause Details What to do when these messages are displayedIndicator About warning indicatorsPlease follow the procedures below Actions to be taken upon warning indicationsTroubleshooting Terminal Description Pin No Signal NamePin Arrangement RS-232C TerminalRS-232C External Control Special parameters External control command tableOperation mode Only Asking command is possible Specifications Front Dimensions Unit mm TopBottom SideMF2MIman v0.90ß