Meridian Audio D-ILA 1080MF2 Loosen the screws on the lamp unit and lift up the handle

Page 29

2 Loosen the screws on the lamp unit and lift up the handle

Handle

● Loosen the 2 screws with a ª screwdriver.

3 Pull out the lamp unit

Lamp Unit

4 Insert the new lamp unit until it is fully in

Caution

Do not touch the glass surface of the lamp directly with your hand or stain it. Touching it with a bare hand may dirty the surface, hence shortening the lamp life, causing marked performance deterioration such as darkened screens, lamp blowout as well as malfunction.

5 Tighten the screws of the lamp unit and

close the handle

● Fasten the 2 screws with a ª screwdriver.

6 Attach the lamp cover and fasten the

screws

●Fasten the 2 screws with a ª screwdriver.

Note

When fitting the lamp cover, insert the left end (with 2 claws) of the lamp cover into the unit, followed by ensuring that the protruding part on the reverse side of the lamp cover fits snugly into the hole of the unit.

As this protrusion acts as a switch, misfitting may lead to failure in turning on the power.

Image 29

Contents ILA 1080MF2 FCC Information U.S.A. only About the installation placeMachine Noise Information Germany only About burning-in of the D-ILA devicePower cord Do not allow any unqualified person to install the unitDo not cut off the main plug from this equipment How To Replace The FuseStandard for gauging replacement time of components Accessories ContentsFront Side/Top Surface/Left Side Controls and FeaturesRear Side/Right Side/Bottom Surface Service Terminal Connector PanelSync OUT Terminal RS-232C Terminal D-sub 9 Pin DVI Terminal DVI-D 24 PinControl Panel Indicator Display on the Control Panel Remote Control Precautions for Using Batteries Loading Batteries into the Remote ControlOpen the back cover Load the batteriesInstallation Environment Installing the ProjectorPrecaution for Usage Adjusting the InclinationMounting this Unit Projector and Screen InstallationPrecautions for Ceiling-mount Screen Size and Projection Distance Screen Installation When directing remote control unit toward this unit Effective Range of Remote Control Unit When reflecting off a screen Connecting to Devices Connecting to Various DevicesRight Side of this unit Control from external deviceWhen using this unit, remove the lens cap Connecting the Power Cord suppliedTurning on the power Basic Operation ProceduresAdjusting zoom screen size Adjusting focusPull out the power plug from the power outlet Turning off the powerHiding the image temporarily Press HideMenu Structure Adjustments and Settings Using MenusMenu Operation Buttons Button Function This Unit Remote Control UnitTo confirm Press the Menu buttonPress 5/ ∞ to select a main menu item and Enter Image adjust Menu Menu ConfigurationSet up Menu Options MenuScreen Masking Press 5/∞ to select Set up, followed by pressingProject image onto the screen Press the Menu buttonPress 5/∞ to select Options, followed by press Ing Enter Picture Shift SettingLight-source Lamp and Lamp Usage Time About Lamp ReplacementReplacing the Lamp Pull out the lamp unit Loosen the screws on the lamp unit and lift up the handleInsert the new lamp unit until it is fully Tighten the screws of the lamp unit Close the handleInsert plug into the power outlet Resetting Lamp TimeTo ensure the lamp time has been reset ExitCleaning and Replacing the Filter Message Cause Details What to do when these messages are displayedIndicator About warning indicatorsPlease follow the procedures below Actions to be taken upon warning indicationsTroubleshooting Terminal Description Pin No Signal NamePin Arrangement RS-232C TerminalRS-232C External Control Special parameters External control command tableOperation mode Only Asking command is possible Specifications Front Dimensions Unit mm TopBottom SideMF2MIman v0.90ß