Marantz Model VP-10S1 manual Initial Setting, Activating the Power, Focusing and Zooming

INITIAL SETTING

Activating the Power

1.Connect the included AC power cable. (☞ pg. 15)

2.Set the ON/OFF switch on the projector rear in the on position. The STANDBY indicator on the projector will light up.

3.Press the POWER ON button on the remote controller or the POWER button on the projector. The POWER ON indicator on the projector will light up.

		STANDBY	POWER ON
			PATTERN
			PATT.
ON	POWER	MENU	V-MUTE
	STANDBY
	MENU	INPUT
		PATTERN
		ENTER
			ENTER

Focusing and Zooming

You can adjust the focus and projected image size using the focus pattern.

1.Press the PATTERN button to project the focus pattern on the screen.

STANDBY POWER ON

PATTERN

PATT.

MENU V-MUTE

ON	POWER
	STANDBY
	MENU	INPUT
		PATTERN

ENTER

ENTER

2.To focus the pattern, press the 1 / 2 buttons on the remote controller or projector. Tapping the buttons fine-adjusts the focus. Holding the buttons down quickly changes the focus. Adjust the focus so that the focus pattern appears its sharpest, as shown below.

3.To adjust the size of the projected image, press the 3 / 4 buttons on the remote controller or projector. Tapping the buttons fine-adjusts the size. Holding the buttons down quickly changes the size.

4.Press the PATTERN button again to cancel the focus pattern. This completes focusing and zooming.

ENGLISH

17