ENGLISH
Color Temperature Adjustment
After replacing the lamp or otherwise when the lighting changes, you can adjust the color temperature using the included color temperature sensor. In the adjustment procedure, you must first initialize the sensor itself before adjusting color temperature. It takes about 10 minutes from when power to the projector is activated for the lamp’s brightness to stabilize. Wait for lamp brightness to stabilize before adjusting color temperature.
1.Connect the cable of the color temperature sensor to the
2.Press the MENU button, select “Color Temp. Calibration” from the menu and press the 2 button. The below message appears on the screen.
Color Temp.Calibration ?
YesNo
3.Use 1 and 2 buttons to select "Yes" and press the ENTER button. The below message appears on the screen.
Initialize
Press "ENTER" to start
Before pressing the ENTER button, turn the color temperature sensor over on its dark side as shown in the below figure, to prevent outside light from penetrating to the sensor’s receptacle.
Receptacle
4.Press the ENTER button. The below message appears on the screen for a few seconds as the sensor itself is being initialized.
Initializing...
5.Fit the color temperature sensor onto the lens and press the ENTER button. The lens automatically shifts to the best position for performing color temperature adjustment. Color temperature adjustment then starts and the projector’s WARNING and STANDBY indicators begin flashing simultaneously.
Attachment for Color temperature sensor
Attach the color temperature sensor so that the cable is to the bottom side of the projector as shown in the figure.
6.When the WARNING and STANDBY indicators go out, color temperature adjustment is complete. Adjustment takes about 4 to 5 min. When the color temperature sensor is detached from the lens, the below message appears on the screen.
Complete
Press "ENTER" to exit
38