Configuration

ENGLISH

You can configure the projector from the following settings.

Menu		Standard 1
Picture Adjust	Auto Power Off	Disable
Setting	Installation	Front
System	Language	English
Display	Focus/Zoom
Config	Lens Shift
Trigger 2	Color Temp. Calibration
Preset	Reset Lamp Life
	Reset All

–Auto Power Off

Auto Power Off	Enable / Disable
Installation	Front, F.Ceiling, Rear, R.Ceiling
Language	English, Français, Deutsch, Español,
	Italiano, Português
Focus/Zoom	Adjusts the focus and size of the projected
	image.
Lens shift	Positions (all directions) the projected
	image on the screen.
Color Temp.	Yes / No
Calibration
Reset Lamp Life	Yes / No
Reset All	Yes / No

When the auto power off feature is turned on, the below message appears on the screen if no signals are received and no operations are performed for 9 consecutive minutes. Power to the projector then shuts off automatically if the situation continues for another minute.

Auto Power Off

It will be standby mode soon.

About 1 minute after the message appears on the screen, power to the projector shuts off.

Note:

After the above message appears on the screen, pressing any button on the projector other than the POWER button or any button on remote controller other than the POWER ON or STANDBY button resets the auto power off feature. The auto power off feature will start counting the time off any time after that, the moment that the projector goes without receiving any signals or being operated in anyway.

–Installation

Sets the projector installation mode.

Front	: Select this mode when the projector is installed on a flat surface in front of the screen.
F. Ceiling	: Select this mode when the projector is mounted on a ceiling in front of the screen.
Rear*	: Select this mode when the projector is installed on a flat surface behind the screen.
R. Ceiling*	: Select this mode when the projector is mounted on a ceiling behind the screen.

*When projecting the image from behind the screen, use a rear-projection screen.

–Focus/Zoom

Adjusts the focus and size of the projected image.

–Lens shift

Positions (all directions) the projected image on the screen. (For details, see “Positioning the Projected Image” ☞ pg. 18.)

–Color Temp. Calibration

After replacing the lamp or otherwise when the lighting changes, you can adjust the color temperature using the color temperature sensor. For instructions on how to adjust color temperature, see “Color Temperature Adjustment” (☞ pg. 38).

–Reset Lamp Life

If you replace the lamp before the 1,500 hour lamp life, be sure to reset the lamp life counter. To do this, select “Reset Lamp Life” from the Config menu. When you do so, the below message appears on the screen.

Reset Lamp Life

YesNo

Select “Yes” and press the ENTER button. This will reset the lamp life counter.