Sharp AL-1650 operation manual Material Safety Data Sheet

Page 59

S H A R P

Date Issued:Nov. 1, 1998

MATERIAL SAFETY DATA SHEET

MSDS No. F-00841

Section 1. Product Identification

Product:

AL-160TD (Black Toner)

Section 2. Supplier’s Name and Address

Sharp Corporation

22-22 Nagaike-cho, Abeno-ku, Osaka, Japan

Local suppliers are listed below. Please contact the nearest supplier for additional information.

(Country)

(Name and Telephone Number)

 

 

 

U.S.A.

Sharp Electronics Corporation

 

 

Telephone number for information:

1-800-237-4277

 

Emergency telephone number:

1-800-255-3924

 

 

 

Canada

Sharp Electronics of Canada Ltd.

 

 

Telephone number for information:

905-890-2100

 

Emergency telephone number:

1-800-255-3924

 

 

 

United Kingdom

Sharp Electronics (U.K.) Ltd.

 

 

Telephone number for information:

01923-474013

 

 

 

Section 3. Ingredients

Ingredients

CAS No. Proportion OSHA PEL

ACGIH TLV Other Limits

Styrene-Acrylate copolymer

 

29497-14-1

> 88 %

Not listed

Carbon black

 

1333-86-4

< 6.0%

3.5mg/m3

Iron oxide

 

1309-38-2

< 4.5%

Not listed

Metal Complex dye

109125-51-1

< 1.5%

0.5mg/m3

 

109125-50-0

 

 

 

84179-66-8

 

 

Not listed

None

3.5mg/m3

None

Not listed

None

0.5mg/m3

None

Section 4. Hazardous Identification (Emergency Overview)

Toner is a fine, black powder possessing no immediate hazard. There are no anticipated carcinogenic effects from exposure based on animal tests performed using toner. When used as intended according to instructions, studies do not indicate any symptoms of fibrosis will occur.

Section 5. Health Hazard Data

Route(s) of Entry:

Inhalation?

Skin?

Ingestion?

 

Yes

No

Possible but very unusual.

Health Hazards: Acute oral toxicity -------- LDL0 of this toner is over 2,000mg/kg.

Mutagenicity -------------- The result of Ames test is negative.

Carcinogenicity: In 1996 the IARC reevaluated carbon black as a Group 2B carcinogen (possible human carcinogen). This classification is given to chemicals for which there is inadequate human evidence, but sufficient animal evidence on which to base an opinion of carcinogenicity. The classification is based upon the development of lung tumors in rats receiving chronic inhalation exposures to free carbon black at levels that induce particle overload of the lung. Studies performed in animal models other than rats did not show any association between carbon black and lung tumors. Moreover, a two-year cancer bioassay using a typical toner preparation containing carbon black demonstrated no association between toner exposure and tumor development in rats.

Chronic Effect:: In a study in rats of chronic inhalation exposure to a typical toner, a mild to moderate degree of lung fibrosis was observed in 92% of the rats in the high concentration (16mg/m3) exposure group, and a minimal to mild degree of fibrosis was noted in 22% of the animals in the middle (4mg/m3) exposure group, but no pulmonary change was reported in the lowest (1mg/m3) exposure group, the most relevant level to potential human exposures.

Signs and Symptoms of Exposure: Minimal irritation to respiratory tract may occur as with exposure to any

 

non-toxic dust.

Medical Conditions Generally Aggravated by Exposure: None

Emergency and First Aid Procedures:

Inhalation; Remove to fresh air. If effects occur, consult medical personnel.

Eye;

In case of contact, immediately flush eyes with water for 15 minutes.

57

Image 59
Contents AL-1650 For Your Protection Contents Safety Precautions Main Features Part Names and Functions Part Names and Functions Alarm indicators AUTO/MANUAL/PHOTO / / key and indicators pOriginal Size Enter key and indicators p Paper Size indicators@0 Preset Ratio selector keys and indicators p Dual page Copy key and indicator pLight and dark keys and indicators Auto Image key and indicator pDo not install your copier in areas that are Copier InstallationGetting Started Unpacking Checking Packed Components and AccessoriesGently lift and pull out the paper tray until it stops Install the TD cartridgeSET-UP Store the pressure plate lock which has been removed Turn the power switch on Load copy paperSET-UP Front of the paper trayPush the paper tray firmly back into the copier Loading Copy PaperLoading Copy Paper Press the Start key and then the Paper Size 11ENTER key Normal Copying Using the SPFTurn the power switch on Adjust the copy densityPress the Start key Set the number of copies using the two copy quantity KeysStream feeding mode Normal CopyingUsing the original table Normal Copying Enter the number of copies Press the Start key REDUCTION/ENLARGEMENT/ZOOMAutomatic Press the Auto Image KeyManual REDUCTION/ENLARGEMENT/ZOOMUnfold the bypass tray Bypass Feed special paperPress the Tray Select key to select the bypass Bypass Feed special paperTWO-SIDED Copying Press the copy ratio display Key XY ZoomPress the XY-ZOOM key Set the number of copies and press the Start key XY ZoomPress the B/W Reverse key Check the copy paper size ReversePress the Dual page Copy key Dual page CopyReplace the original for the interrupted job and press Interrupting a Copy RUNPress the Interrupt key Start key to resume copyingAutomatic Exposure Adjustment To enter the toner save mode, press the light key Toner Save ModePress the AUTO/MANUAL/PHOTO Key To select the Manual Mode Genuine Supplies TD Cartridge ReplacementTD Cartridge Replacement By the right hand. Lift the cartridge by the handle while To remove itCartridge out until the green strap handle can be grasped Gently install the TD cartridge. To install the TD cartridge Drum Cartridge ReplacementRight feeding roller cover and remove the misfed Misfeed RemovalMisfeed in the SPF First confirm the misfeed locationGently pull the misfed paper out Misfeed RemovalMisfeed in the bypass tray Misfeed in the copierPush gently the right side of the front cover to open Cover Fusing unit is hot. Take care in removing paperRemoving it On either side of the guide and remove the misfed paper Open the paper guide by pressing down the projectionClose the side cover by pressing the handle on the cover Misfeed in the upper paper trayMisfeed in the lower paper tray Remove the misfed paper List of user programs Setting the user programsEnter a program number using the left copy quantity Key User ProgramsUser Programs Select the desired parameter using the right copy quantityAuto power shut-off mode Power Save ModesPreheat mode Copying from the preheat mode Power Save ModesSetting the power save modes Transfer charger User MaintenanceOriginal table and document feeder cover Bypass tray paper feed rollerGently lift and pull out the upper paper tray and take User MaintenanceCharger cleaner out by holding the tab Copier TROUBLE? Problem SolutionExample Self-diagnostic functionCopier TROUBLE? Supply list SuppliesTypes and sizes of copy paper Supply part numbersStore copy paper in the wrapper and lying flat SuppliesGenuine supplies statement Proper storagePush the paper tray back into the copier Turn the power switch off and disconnect the power CordMoving Instructions Copier SpecificationsSingle Pass Feeder SpecificationsIndex Index Material Safety Data Sheet Flammable Limits Ignition TemperatureSpecial Fire Fighting Procedure Flash Point Method UsedHealth Hazards Ingredients CAS No ProportionOther Limits None required under normal use Memo Memo Page Sharp Corporation