Sharp AR-207 operation manual Material Safety Data Sheet, Product, Routes of Entry

Page 78

Date Issued: Nov. 1, 2000

MATERIAL SAFETY DATA SHEET

MSDS No. F-00991

Section 1. Product Identification

Product:

AR-201NT/T/FT/ST (Black Toner)

Section 2. Supplier’s Name and Address

Sharp Corporation

22-22 Nagaike-cho, Abeno-ku, Osaka, Japan

Local suppliers are listed below. Please contact the nearest supplier for additional information.

 

(Country)

(Name and Telephone Number)

 

 

 

 

 

 

 

U.S.A.

Sharp Electronics Corporation

 

 

 

 

Telephone number for information:

1-800-237-4277

 

 

 

Emergency telephone number:

1-800-255-3924

 

 

 

 

 

 

 

Canada

Sharp Electronics of Canada Ltd.

 

 

 

 

Telephone number for information:

905-890-2100

 

 

 

Emergency telephone number:

1-800-255-3924

 

 

 

 

 

 

 

United Kingdom

Sharp Electronics (U.K.) Ltd.

 

 

 

 

Telephone number for information: 01923-474013

 

 

 

 

 

 

 

 

 

 

 

Section 3. Ingredients

Ingredients

CAS No. Proportion OSHA PEL

ACGIH TLV Other Limits

Styrene-Acrylate copolymer

29497-14-1

> 88 %

Not listed

Carbon black

1333-86-4

< 6.0%

3.5mg/m3

Iron oxide

1309-38-2

< 4.5%

Not listed

Metal Complex dye

109125-51-1

< 1.5%

0.5mg/m3

 

{109125-50-0

 

 

 

84179-66-8

 

 

Not listed

None

3.5mg/m3

None

Not listed

None

0.5mg/m3

None

Section 4. Hazardous Identification (Emergency Overview)

Toner is a fine, black powder possessing no immediate hazard.There are no anticipated carcinogenic effects from exposure based on animal tests performed using toner. When used as intended according to instructions, studies do not indicate any symptoms of fibrosis will occur.

Section 5. Health Hazard Data

Route(s) of Entry:

Inhalation?

Skin?

Ingestion?

 

Yes

No

Possible but very unusual.

Health Hazards: Acute oral toxicity ------- LDL0 of this toner is over 2,000mg/kg.

 

Mutagenicity -------------

The result of Ames test is negative.

Carcinogenicity: In 1996 the IARC reevaluated carbon black as a Group 2B carcinogen (possible human carcinogen). This classification is given to chemicals for which there is inadequate human evidence, but sufficient animal evidence on which to base an opinion of carcinogenicity. The classification is based upon the development of lung tumors in rats receiving chronic inhalation exposures to free carbon black at levels that induce particle overload of the lung. Studies performed in animal models other than rats did not show any association between carbon black and lung tumors. Moreover, a two-year cancer bioassay using a typical toner preparation containing carbon black demonstrated no association between toner exposure and tumor development in rats.

Chronic Effect: In a study in rats of chronic inhalation exposure to a typical toner, a mild to moderate degree of lung fibrosis was observed in 92% of the rats in the high concentration (16mg/m3) exposure group, and a minimal to mild degree of fibrosis was noted in 22% of the animals in the middle (4mg/m3) exposure group, but no pulmonary change was reported in the lowest (1mg/m3) exposure group, the most relevant level to potential human exposures.

Signs and Symptoms of Exposure: Minimal irritation to respiratory tract may occur as with exposure to any

 

non-toxic dust.

Medical Conditions Generally Aggravated by Exposure: None

Emergency and First Aid Procedures:

Inhalation;

Remove to fresh air. If effects occur, consult medical personnel.

Eye;

In case of contact, immediately flush eyes with water for 15 minutes.

76

Page 77 Page 79
Image 78
Page 77 Page 79
Contents AR-207 Safety Precautions Contents Introduction Conventions used in this manualMain Features Part Names and Functions Part Names and Functions Paper Size indicators Interrupt key and indicator pZoom indicator p.24 Alarm indicatorsOriginal Size Enter key and indicators Start key and indicatorPreset Ratio selector keys and indicators Auto Paper Select indicatorCopier Installation Do not install your copier in areas that areAlso make certain the outlet is properly grounded Do not touch the photoconductive drum green portion Loading Copy Paper Gently lift and pull out the paper tray until it stopsPush the paper tray firmly back into the copier Loading Copy Paper Press the Start key and then the Paper Size Enter 11 key When copying is completed, press the Audit Clear Key Enter your account number using the numeric keysAuditing Accounts Stream feeding mode Power onTurn the power switch on Normal CopyingAdjust the copy density Ensure that the one-sided to one-sided copying mode isNormal Copying Press the Start key Set the number of copies using the numeric keysTwo-sided copies from one-sided originals Ensure that no original is left on the original tableTwo-sided copies from two-sided originals Set the number of copies and press the Start keySet the number of copies and press the Start key One-sided copies from two-sided originals Original has been set in the document feeder trayClose the document feeder cover Ensure that the desired paper tray is selectedCopying from the Original Table Copying from the original table Setting image rotation in duplex copying Select the desired parameter using the numeric keysPress the Original to Copy key REDUCTION/ENLARGEMENT/ZOOM AutomaticRatio, then press REDUCTION/ENLARGEMENT/ZOOMManual To increase the ratioBypass Feed special paper Unfold the bypass trayBypass Feed special paper SORT/GROUP Sort modeGroup mode Offset stackCopying in the sort mode SORT/GROUPSet the originals face up in the document feeder tray Interrupting a Copy RUN Automatic Exposure Adjustment Toner Save Mode To enter the toner save mode, press the light keyXY Zoom Press the copy ratio display keyUse the Preset Ratio selector , keys and zoom XY ZoomReverse Dual page Copy Press the Dual page Copy keyPlace the originals on the original table with the center Rotation Copying 2 x 11 is performed, the image cannot be rotated1 or 4 Enter the desired pattern number using a numeric key Press the 2 in 1 / 4 in 1 key to complete the selectionPress the Erase key to select the desired erase mode EraseEnsure that the desired copy paper size is selected Erase Place the original in the document feeder tray or on Until the Margin Shift indicator will blinkMargin Shift To confirm or set the location of the margin, pressToner Cartridge Replacement Push the toner cartridge lock release lever and pullThan 5 seconds Toner Cartridge ReplacementToner cartridge life Press the light keyMisfeed in the Rspf First confirm the misfeed locationMisfeed in the copier Misfeed RemovalMisfeed in the bypass tray If the misfed original cannot be removed in steps 1Removing it Push gently on both sides of the front cover to open CoverTurn the roller rotating knob in the direction ArrowMisfeed in the upper paper tray Close the side cover by pressing the handle on CoverClose the paper tray Close the lower side cover Misfeed in the lower paper trayPull out the lower paper tray and remove the misfed paper If the misfed paper is not seen in , gently liftMaintenance Required Developer RequiredUser Programs List of user programsProgram Program name Description User Programs Setting the user programsEnter a program number using the numeric keys Program name Program NoTo continue with other user programs, press the key Settings for auditing accounts Select the desired setting using the numeric keysEnter a 3-digit account number using the numeric keys Number to be changed Use the copy ratio display key to select the accountUse the copy ratio display key to select the account Number Press and hold down the 0 keyProgram No Resetting account Power Save Modes Preheat modeAuto power shut-off mode Copying from the preheat mode Power Save ModesSetting the power save modes Copying from the auto power shut-off modeOriginal table and document feeder cover User MaintenanceBypass tray with a soft, clean cloth dampened with Bypass tray paper feed rollerCharger cleaner out by holding the tab User MaintenanceTransfer charger cleaning Gently lift and pull out the upper paper tray and takeProblem Solution Copier TROUBLE?Problem Copier TROUBLE?COPY/FAX key Self-diagnostic function ExampleSupplies Types and sizes of copy paperProper storage SuppliesGenuine supplies statement Store the supplies in a location that isSpecifications RspfSpecifications Reversing Single Pass FeederOptional Equipment System Configuration Part Names Loading copy paperMisfeed removal Specifications AR-DE5Index Index Product Material Safety Data SheetEmergency and First Aid Procedures Routes of EntrySpecific Gravity Vapor Pressure Ignition TemperatureSpecial Fire Fighting Procedure Vapor DensityHealth Hazards IngredientsProportion Medical Conditions Generally Aggravated by ExposureEvaporation Rate Not applicable Viscosity Appearance Fine powder Color Black Odor OdorlessMemo For users in the USA Sharp Corporation
Top Page Image Contents