Sharp LL-T15A4 Connecting the monitor to a computer, Connect the accessory audio cable

Connecting the monitor and turning the monitor on and off

CAUTION! Connect the accessory audio cable

-When connecting, ensure that both the monitor and computer are switched off.

-Be careful not to overly bend the cable or add extension cords as this could lead to a malfunction.

Connecting the monitor to a computer

Analog RGB terminal (Mini D-Sub15 pin, 3 row)

Analog signal cable

-Paying attention to connector direction, firmly insert the signal cable to terminal, and then tighten the screws at both sides.

If connecting to a D-sub15 pin 2 row Apple Power Macintosh, attach a Macintosh conversion adapter (commercially available) to the analog signal cable.

Macintosh conversion adapter

Note:

-When connecting to a notebook, if the notebook computer's screen is set to display at the same time, the MS-DOS screen may not be able to display properly. In this case, change the settings to display only on the monitor.

When the accessory audio cable is connected to the audio output terminal of the computer, the sound of the connected computer is output from the monitor speakers. You can also use the headphone jack of the display.

Audio input terminal

Audio output terminal

Audio cable

Connection of headphones (commercially available)

Headphones (commercially available) can be connected.

Headphone terminal

Head- phones

Note:

-When the headphones are connected, no sound can be heard from the monitor speakers.

English

11