Runco CL-610 manual Operation, Selecting Video Memory, Selecting an Aspect Ratio

4. Operation

• Press the MEM1 button on the remote control

to recall settings for the current input from the	MEM1	ISF	ISF	FACT
		NIGHT	DAY
“Memory 1” memory preset.

•Press ISF NT (Night) to recall settings for the current input from the “ISF Night” memory preset.

•Press ISF DAY to recall settings for the current input from the “ISF Day” memory preset.

Press FACT to recall the factory-default settings for the current input. An on-screen confirmation message appears. Press FACT again to confirm.

4.1

Selecting Video Memory

Use these buttons to select the appropriate aspect ratio for the type of program material being viewed. For more information on aspect ratios, refer to Table 4-1.

ANA

16X9

CINEMA

4X3	LBOX	VWIDE
1	2	VCINE

4.2

Selecting an Aspect Ratio

When you turn on the CL-610, it switches to the last selected input and looks for a valid signal.

Use these buttons on the remote control to select an input source directly.

VID S-VID COMP1 COMP2

RGBHD HDMI

4.3

Selecting An Input Source

For PIP and PBP purposes, there are two groups of
inputs separated by their display modes:	PBP	ACT	PIP	PIP+
• Video (SD) group: Video, S-Video and				PIP-
Component 1 inputs.

•Graphic (HD) group: HDMI and Component 2/RGB inputs.

PIP and PBP show one input from the Graphic group within or beside one input from the Video group respectively.

•Press PBP to enable the PBP function. Press PBP again to switch the screens left to right. Press PBP again to turn PBP off.

•Press ACTIVE to switch to the active window. (You can only switch inputs in the active window.)

•Press PIP to enable the PIP function. Press PIP again to switch the main window. Press PIP again to turn PIP off.

•To adjust the size of the PIP window, press PIP+ or PIP-.

•Adjust the position of the PIP window with the arrow buttons ( , , , ).

4.4 Using

Picture-In-Picture and Picture-By-Picture (PIP/PBP)

Runco CL-610 Series Owner’s Operating Manual 29