Maintenance and Troubleshooting
5.2
Troubleshooting Tips
Table
Table 5-1. Troubleshooting Chart
Symptom |
| Possible Cause(s) |
| Solution |
|
|
|
| |
The projector does not turn | • | The | • Ensure that the | |
on. |
| in or the AC outlet is not |
| plugged in and that the AC |
|
| active. |
| outlet is active. |
| • The main power switch (at | • Turn on the power switch. | ||
|
| the rear of the projector) is |
|
|
|
| off. |
|
|
| • Lamp cover is not securely | • Securely attach the lamp | ||
|
| attached. |
| cover. |
|
|
|
| |
The projector does not turn | • | The projector will not turn | • Wait until the | |
back on after it was powered |
| on for two minutes after |
| completes its |
off. |
|
| (POWER LED lights solid | |
|
| lamp. |
| orange). |
|
|
|
|
|
The remote control does not | • | The batteries have run out. | • | Replace the batteries. |
work correctly. |
|
|
|
|
|
|
|
| |
The projector is on and OSD | • | Incorrect source selection. | • Select the correct source. | |
menus appear, but there is no | • | Source component is not | • Turn on the source. | |
video image |
| turned on. |
|
|
| • | Source component is | • | Check cable connection |
|
| connected incorrectly or |
| from source component to |
|
| not at all. |
| projector. |
|
|
|
| |
A projected image from a | • | DVD player is connected | • Turn off progressive scan | |
DVD is split or otherwise |
| to the Component input |
| on the DVD player. |
scrambled. |
| and set to progressive |
|
|
|
| scan mode. |
|
|
|
|
|
| |
Image is blurred. | • | The lens is not correctly | • Adjust the focus by turning | |
|
| focused. |
| the focus ring. |
|
|
|
| |
Image is too bright and/or | • | Contrast is set too high. | • Lower the contrast setting. | |
lacks definition in the bright |
|
|
|
|
areas of the image. |
|
|
|
|
|
|
|
|
|
Image appears “washed out” | • | Brightness is set too high. | • | Lower the brightness |
and/or dark areas appear too |
|
|
| setting. |
bright. |
|
|
|
|
|
|
|
| |
Colors in the image are | • | The Red/Pr, Green/Y or | • Ensure that the source | |
swapped; for example, reds |
| Blue/Pb outputs from the |
| outputs are connected to |
appear blue or vice versa. |
| source are connected to |
| the correct |
|
| the wrong inputs on the |
|
|
|
|
|
| |
|
|
|
| |
TEMP and LAMP LEDs are | • | The lamp cover is open. | • Close the lamp cover. | |
both flashing red. | • | Fans are not working | • Please contact your Runco | |
|
| properly. |
| dealer for assistance. |
50 | Runco |