Allied Telesis AT-X210-16GT, AT-X210-9GT, AT-X210-24GT manual

Page 17

LEDs

Installation Options

Power Conservation

MAC Address Table

AT-x210-9GT, AT-x210-16GT, and AT-x210-24GT Switches Installation Guide

Here is a brief description of the port LEDs:

„Power LED/Fault/Standby LEDs; refer to “POWER/FAULT/ STANDBY LEDs” on page 13.

„Speed and link/activity LEDs for the twisted pair ports; see “10Base-T/100Base-TX/1000 Base-T Link Activity LEDs” on page 15.

„Link/activity LEDs for the SFP slots; see “SFP LEDs” on page 17.

The AT-x210-9GT switch can be installed in the following way:

„Mounted on a Desk or tabletop

The AT-x210-16GT and AT-x210-24GT switches can be installed in the following ways:

„Rack mounted in a19-inch equipment rack

„Mounted on a Desk or tabletop

„Wall mounted

The AT-x210-9GT, AT-x210-16GT, and AT-x210-24GT switches have the following power conservation features:

„High-efficiency power supply

„Power scaling based on traffic loads on ports operating at 1000 Mbps (Port power scaling not available at 10 or 100 Mbps)

„Power shutdown on unused ports

Here are the basic features of the MAC address table:

„Storage capacity up to 8KB MAC address entries

„Automatic learning and aging

7

Image 17
Contents Installation Guide Copyright 2013 Allied Telesis, Inc Electrical Safety and Emissions Standards Translated Safety Statements Contents Contents Figures List of Figures Tables List of Tables Viii Preface Symbol Conventions Contacting Allied Telesis Page Chapter OverviewSFP Slots FeaturesPage Package Contents AT-x210-9GT Front and Back PanelsAT-x210-9GT Management Software Twisted Pair Ports LEDs PowerStandby 10Base-T/ 100Base-TX/1000 Base-T Link Activity LEDs AT-x210-16GT Link/Activity LEDs AT-x210-9GT SFP Speed and Link/Activity LEDs SFP Power Supply Overview Installation Reviewing Safety Precautions Page Selecting a Site for the Switch Type of Cable Cable SpecificationsUnpacking the Switch Installing the Switch on a Table or a Desktop Speed Duplex Installing the Switch in an Equipment RackMounting an AT-x210-24GT Switch in an Equipment Rack Close up showing a bracket positioned for an AT-x210-9GT Mounting an AT-x210-16GT Switch in an Equipment Rack Fitting brackets to the mounting for an AT-x210-9GT Mounting an AT-x210-9GT Switch in an Equipment Rack Securing cables to the cable tray for an AT-x210-9GT Installing Optional SFP Transceivers Inserting the SFP on an AT-x210-16GT SFP Transceiver Handle Installation Cabling the Switch Installation Powering On the Switch Installation Monitoring the Initialization Processes Switch Initialization MessagesSwitch Initialization Messages Switch Initialization Messages Installation Troubleshooting Troubleshooting Page Troubleshooting Appendix a Technical SpecificationsEnvironmental Specifications Physical SpecificationsPower Specifications Pin Signal Connectors and Port PinoutsPin Pair Signal Appendix a Technical Specifications