Installing the Switch on a Table or a Desktop
You can install
Here are the guidelines to selecting a suitable site for desktop or table use:
The table should be level and stable and the power outlets should be located near the switches and be easily accessible.
The site should allow for easy access to the ports on the front of the switches, so that you can easily connect and disconnect cables, and view the port LEDs.
The site should not expose the switches to moisture or water and the site should be a
The site should include dedicated power circuits or power conditioners to supply reliable electrical power to the network devices.
The rubber feet on the bottom of the switches should be left on for table or desktop installation.
If you switch does not already have rubber feet fitted, fit these as follows:
1.Remove all equipment from the package and store the packaging material in a safe place.
2.Turn the switch over and place it on a table.
3.Screw the four rubber feet to the bottom of the switch as shown below:
1971
Figure 14. Attaching the Rubber Feet
4.Turn the switch over again and place it on a flat, secure surface (such as a desk or table) leaving ample space around the unit for ventilation.
5.Go to “Installing Optional SFP Transceivers” on page 35 or “Cabling the Switch” on page 39.
27