Allied Telesis AT-X210-16GT, AT-X210-9GT Installing the Switch in an Equipment Rack, Speed Duplex

Chapter 2: Installation

Installing the Switch in an Equipment Rack

Note: These instructions show you how to install an AT-x210-9GT, AT-x210-16GT or AT-x210-24GT switch in an equipment rack. Rack mount kit brackets are included with AT-x210-16GT and AT-x210-24GT switches. The AT-x210-9GT switch is installed in a rack with the optional AT-x210-9GT rack mount kit (Part Number 990-003904-00).

To install AT-x210-9GT, AT-x210-16GT or AT-x210-24GT switches in a

19-inch equipment rack, follow these steps:

1. Place the unit upside down on a level, secure surface.

1971

Figure 15. Turning the Switch Upside Down

2.Unscrew the rubber feet from the bottom and turn the switch over.

3.For AT-x210-24GT Switches, attach two rack mount brackets to the sides of the switch using the bracket screws that come with the unit.

RESET FAULT
FAULT		CONSOLE
STANDBY
POWER	STANDBY

	MODE
RS-	SELECTMODE									L/A
	SELECT SPEED	11
RS232-232	SPEED			3	3					L/A
						5	5
	DUPLEX		2	4				7	7		9
		2								9
					4	6	6
								8	8	10

LINK
LINK/		/
SPEED		/
11
11	13
12	14

ACTACT
DUPLEX
15R
15R 17
	17	19
16R		21	23R
	18
		20
		22	24R

L/A MODE L/A MODE

1
3
55
77
2		99
4		1111
66
		1313
8
	8	15R
		15R
		1010	1717
		1212
			1919
		1414	2121
		16R
			23R
		16R
			23R
			1818
			2020
			2222
			24R
			24R

1515 1616 2323 2424

L/A L/A

LINK/
15LINK	/	ACTACT
15

ATGi -
gabitx210
Ether	-
1616		24GTtch
	net Swi
2323
SFPSFP		2424

Figure 16. Attaching brackets to an AT-x210-24GT

28