RTS ADAM manual Fail-Over Modes

Page 10

Fail-Over Modes

Unlike the DBX card, audio and communications (called control1) between frames is separated between the TBX-Tribus card and the MCII-e Master Controller Card. Communication between frames using TBX-Tribus occurs using the MCII-e Master Controller over Ethernet. Audio is passed between frames using the TBX-Tribus card fiber connection (see Figure 29 to Figure 31).

Audio between frames exists as long as there is a single valid link between frames. There are three (3) types of system configurations:

•Full Redundancy

•Partial Redundancy

•Non-Redundancy

1. Control is the ability to talk to keypanels and act on key presses.

6

Image 10

Contents Adam See the enclosed warranty card for further details Contents Page Figures Page General Description Version RequirementsFeatures Interface with AdamConfiguration Requirements SpecificationsBoard Performance Fail-Over Modes Full Redundancy Partial Redundancy Non-Redundancy Page Eight Frame Tribus System Non-Redundant Page Debug Information Uploading Debug Information Status window appears To find the file you just created, do the following Navigate to C\Telex\AZedit\DebugPage To install the Tribus into an Adam frame, do the following InstallationRequirements Configuration Intercom Configuration window appears Click Intercom Sizing Wizard Select the The number of frames in the intercom radio buttonSelect the Enable Test Audio recommended check box Intercom Configuration window reappears Click the Frame 2 IP Address 1 field Click the browse buttonBase 8 vs. Base 16 Port Number Systems Base 8 Port Number SystemPage Base 16 Port Number System Base 16 Port Numbering System ExampleForce Autonomous Mode Check Box AZedit Connections Connect To Frame MenuFrame Mapping Table Window Frame ColumnIP Address 2 Column IP Address 1 ColumnMAC Address 1 Column MAC Address 2 ColumnMove Down Button Base 16 Column Check BoxMove Up Button Accept Frame Mapping Table from Other Frames Check BoxTest Button Select Frame WindowDone Button Cancel Button OK ButtonTBX Column TBX Links Status WindowComm Column Link Up/Dn Column Partner ColumnAudio B Column Intercom AlarmsAudio a Column Audio C ColumnTo open the Intercom Alarms window, do the following Intercom Alarms WindowResolved Time Column Alarm Time ColumnDescription Column Configure Logging Window Logging WindowJ10 Radio Button J1 Radio ButtonJ9 Radio Button Ethernet Radio ButtonDownload Firmware Upgrades Download Firmware to the TBX-Tribus CardFirmware Download window appears Click Begin DownloadVerify the Tribus card firmware has been updated Successful Download Message Click OK