RTS ADAM Installation, Requirements, To install the Tribus into an Adam frame, do the following

Page 21

CHAPTER 2

Installation and Configuration

Installation

Requirements

•10 Base-T or 100 Base TX Ethernet connection to the network

•AZedit 3.6.1 or higher

•MCII-e Master Controller 2.0.4 or higher

To install the Tribus into an ADAM frame, do the following:

1.Firmly push the back card into slot 8, 9, or 10 in the ADAM frame.

NOTE: Depending on the number of Tribus cards you are using determines the slot the card will occupy. 1 card = slot 8, 2 cards = slots 8 and 9, and 3 cards = slots 8, 9, 10.

2.Using a screwdriver, secure the back card into the frame with the provided screws.

3.Firmly push the front card into the front corresponding back card slot.

4.Securely lock the front card in place with the top and bottom extractor handles.

FIGURE 36. Tribus Backcard Slots

17

Image 21

Contents Adam See the enclosed warranty card for further details Contents Page Figures Page Version Requirements General DescriptionInterface with Adam FeaturesSpecifications Configuration RequirementsBoard Performance Fail-Over Modes Full Redundancy Partial Redundancy Non-Redundancy Page Eight Frame Tribus System Non-Redundant Page Debug Information Uploading Debug Information Status window appears Navigate to C\Telex\AZedit\Debug To find the file you just created, do the followingPage Installation To install the Tribus into an Adam frame, do the followingRequirements Configuration Intercom Configuration window appears Select the The number of frames in the intercom radio button Click Intercom Sizing WizardSelect the Enable Test Audio recommended check box Intercom Configuration window reappears Click the browse button Click the Frame 2 IP Address 1 fieldBase 8 Port Number System Base 8 vs. Base 16 Port Number SystemsPage Base 16 Port Numbering System Example Base 16 Port Number SystemForce Autonomous Mode Check Box Connect To Frame Menu AZedit ConnectionsFrame Column Frame Mapping Table WindowMAC Address 1 Column IP Address 1 ColumnIP Address 2 Column MAC Address 2 ColumnMove Up Button Base 16 Column Check BoxMove Down Button Accept Frame Mapping Table from Other Frames Check BoxSelect Frame Window Test ButtonDone Button OK Button Cancel ButtonTBX Links Status Window TBX ColumnComm Column Partner Column Link Up/Dn ColumnAudio a Column Intercom AlarmsAudio B Column Audio C ColumnIntercom Alarms Window To open the Intercom Alarms window, do the followingAlarm Time Column Resolved Time ColumnDescription Column Logging Window Configure Logging WindowJ9 Radio Button J1 Radio ButtonJ10 Radio Button Ethernet Radio ButtonDownload Firmware to the TBX-Tribus Card Download Firmware UpgradesClick Begin Download Firmware Download window appearsSuccessful Download Message Click OK Verify the Tribus card firmware has been updated