RTS ADAM manual Specifications, Board Performance, Configuration Requirements

Specifications

Board Performance

Throughput Per Link:

360Mb/sec

SFP Fiber Transceivers:

Voltage:

3.3V Rails

Standard Rate:

SONET OC12 or Gigabit Ethernet Recommended Parts:

Multi-Mode:

Finisar - FTLF8519P2BNL (Oxide VCSEL, Maximum reach of 550m) Single Mode:

Finisar - FTLF1422P1BTL (1310nm, Maximum reach 40km)

Fiber Cable Connector Type:

Multiple Mode Fiber LC–LC Duplex Connector – max length 500m (546.8 yd.)

Single Mode Fiber LC–LC Duplex Connector – max length 40km (24.9 miles)

Configuration Requirements

An MCII-e Master Controller card must be installed in the same frame as the TBX-Tribus. For more information, see the MCII-e User Manual which can be found at www.rtsintercoms.com.

TABLE 1. Systems Supported by the TBX-Tribus Card

Links Used		# TBX Cards	System	Frames Supported	Channels
		per Frame
1	1		AIO-8	2	256
1	1		AIO-16	2	512
3	1		AIO-8	3	384
3	1		AIO-16	3	768
6	1		AIO-8	4	512
6	1		AIO-16	4	880
10	2		AIO-8	5	640
10	2		AIO-16	5	880
15	2		AIO-8	6	768
15	2		AIO-16	6	880
21	2		AIO-8	7	880
21	2		AIO-16	7	880
28	3		AIO-8	8	880
28	3		AIO-16	8	880

NOTE: The TBX–Tribus supports up to eight (8) frames in non-redundant mode. Slot 10 should be used if a third TBX– Tribus card is needed.

5