RTS ADAM manual Frame Mapping Table Window, Frame Column

Page 33

CHAPTER 3

Window Descriptions

Frame Mapping Table Window

The Frame Mapping Table window, shown in Figure 42, is used to link Tribus frames together. Determine the frame position (1 through 8) and enter the primary and secondary MCII-e Master Controller IP Addresses.

FIGURE 42. Frame Mapping Table

Frame Column

The Frame column displays the frame’s positional rank within the intercom system.

29

Image 33

Contents Adam See the enclosed warranty card for further details Contents Page Figures Page Version Requirements General DescriptionInterface with Adam FeaturesSpecifications Configuration RequirementsBoard Performance Fail-Over Modes Full Redundancy Partial Redundancy Non-Redundancy Page Eight Frame Tribus System Non-Redundant Page Debug Information Uploading Debug Information Status window appears Navigate to C\Telex\AZedit\Debug To find the file you just created, do the followingPage Installation To install the Tribus into an Adam frame, do the followingRequirements Configuration Intercom Configuration window appears Select the The number of frames in the intercom radio button Click Intercom Sizing WizardSelect the Enable Test Audio recommended check box Intercom Configuration window reappears Click the browse button Click the Frame 2 IP Address 1 fieldBase 8 Port Number System Base 8 vs. Base 16 Port Number SystemsPage Base 16 Port Numbering System Example Base 16 Port Number SystemForce Autonomous Mode Check Box Connect To Frame Menu AZedit ConnectionsFrame Column Frame Mapping Table WindowMAC Address 1 Column IP Address 1 ColumnIP Address 2 Column MAC Address 2 ColumnMove Up Button Base 16 Column Check BoxMove Down Button Accept Frame Mapping Table from Other Frames Check BoxSelect Frame Window Test ButtonDone Button OK Button Cancel ButtonTBX Links Status Window TBX ColumnComm Column Partner Column Link Up/Dn ColumnAudio a Column Intercom AlarmsAudio B Column Audio C ColumnIntercom Alarms Window To open the Intercom Alarms window, do the followingAlarm Time Column Resolved Time ColumnDescription Column Logging Window Configure Logging WindowJ9 Radio Button J1 Radio ButtonJ10 Radio Button Ethernet Radio ButtonDownload Firmware to the TBX-Tribus Card Download Firmware UpgradesClick Begin Download Firmware Download window appearsSuccessful Download Message Click OK Verify the Tribus card firmware has been updated