RTS ADAM manual Configure Logging Window

Page 43

Logging Window

The AZedit Logging window, shown in Figure 50, displays the log messages about the events that have occurred in the cluster. The log messages are kept locally on each frame. These normally are identical, with the exception of when the frames are re- synchronizing, across the intercom cluster.

FIGURE 50. Log Viewer Window

Configure Logging Window

The Configure Logging window, shown in Figure 51, is used to configure the connection type of the AZedit session where log messages are sent when the Log to File option is selected. The Configure Logging window is only accessible when connected to AZedit using the J1 serial connection or using the start AZedit session.

FIGURE 51. Configure Logging Window

39

Image 43

Contents Adam See the enclosed warranty card for further details Contents Page Figures Page Version Requirements General DescriptionInterface with Adam FeaturesConfiguration Requirements SpecificationsBoard Performance Fail-Over Modes Full Redundancy Partial Redundancy Non-Redundancy Page Eight Frame Tribus System Non-Redundant Page Debug Information Uploading Debug Information Status window appears Navigate to C\Telex\AZedit\Debug To find the file you just created, do the followingPage To install the Tribus into an Adam frame, do the following InstallationRequirements Configuration Intercom Configuration window appears Select the The number of frames in the intercom radio button Click Intercom Sizing WizardSelect the Enable Test Audio recommended check box Intercom Configuration window reappears Click the browse button Click the Frame 2 IP Address 1 fieldBase 8 Port Number System Base 8 vs. Base 16 Port Number SystemsPage Base 16 Port Numbering System Example Base 16 Port Number SystemForce Autonomous Mode Check Box Connect To Frame Menu AZedit ConnectionsFrame Column Frame Mapping Table WindowMAC Address 2 Column IP Address 1 ColumnMAC Address 1 Column IP Address 2 ColumnAccept Frame Mapping Table from Other Frames Check Box Base 16 Column Check BoxMove Up Button Move Down ButtonTest Button Select Frame WindowDone Button OK Button Cancel ButtonTBX Column TBX Links Status WindowComm Column Partner Column Link Up/Dn ColumnAudio C Column Intercom AlarmsAudio a Column Audio B ColumnIntercom Alarms Window To open the Intercom Alarms window, do the followingResolved Time Column Alarm Time ColumnDescription Column Logging Window Configure Logging WindowEthernet Radio Button J1 Radio ButtonJ9 Radio Button J10 Radio ButtonDownload Firmware to the TBX-Tribus Card Download Firmware UpgradesClick Begin Download Firmware Download window appearsSuccessful Download Message Click OK Verify the Tribus card firmware has been updated