RTS ADAM manual To open the Intercom Alarms window, do the following, Intercom Alarms Window

Page 41

To open the Intercom Alarms window, do the following:

1.Double-click the yellow highlighted alarm in the status bar.

OR

From the Status menu, select Alarms.

The Intercom Alarms window appears.

FIGURE 49. Intercom Alarms Window

37

Image 41
Contents Adam See the enclosed warranty card for further details Contents Page Figures Page Version Requirements General DescriptionInterface with Adam FeaturesBoard Performance SpecificationsConfiguration Requirements Fail-Over Modes Full Redundancy Partial Redundancy Non-Redundancy Page Eight Frame Tribus System Non-Redundant Page Debug Information Uploading Debug Information Status window appears Navigate to C\Telex\AZedit\Debug To find the file you just created, do the followingPage Requirements InstallationTo install the Tribus into an Adam frame, do the following Configuration Intercom Configuration window appears Select the The number of frames in the intercom radio button Click Intercom Sizing WizardSelect the Enable Test Audio recommended check box Intercom Configuration window reappears Click the browse button Click the Frame 2 IP Address 1 fieldBase 8 Port Number System Base 8 vs. Base 16 Port Number SystemsPage Base 16 Port Numbering System Example Base 16 Port Number SystemForce Autonomous Mode Check Box Connect To Frame Menu AZedit ConnectionsFrame Column Frame Mapping Table WindowMAC Address 1 Column IP Address 1 ColumnIP Address 2 Column MAC Address 2 ColumnMove Up Button Base 16 Column Check BoxMove Down Button Accept Frame Mapping Table from Other Frames Check BoxDone Button Select Frame WindowTest Button OK Button Cancel ButtonComm Column TBX Links Status WindowTBX Column Partner Column Link Up/Dn ColumnAudio a Column Intercom AlarmsAudio B Column Audio C ColumnIntercom Alarms Window To open the Intercom Alarms window, do the followingDescription Column Alarm Time ColumnResolved Time Column Logging Window Configure Logging WindowJ9 Radio Button J1 Radio ButtonJ10 Radio Button Ethernet Radio ButtonDownload Firmware to the TBX-Tribus Card Download Firmware UpgradesClick Begin Download Firmware Download window appearsSuccessful Download Message Click OK Verify the Tribus card firmware has been updated