RTS ADAM manual Uploading Debug Information Status window appears

Page 18

1.From the Options menu, select Upload Debug Information. The Upload Debug Information window appears.

FIGURE 33. Upload Debug Information window

NOTE: By default, the Debug folder (C:\Telex\AZedit\Debug) is where the AZedit debug file you create is stored.

2.In the File name field, enter a name for the debug file you create. For example, you could use the date as the file name – 12152008.azd.

3.Click Save.

The Uploading Debug Information Status window appears.

FIGURE 34. Uploading Debug Information Status window

14

Image 18

Contents Adam See the enclosed warranty card for further details Contents Page Figures Page General Description Version RequirementsFeatures Interface with AdamSpecifications Configuration RequirementsBoard Performance Fail-Over Modes Full Redundancy Partial Redundancy Non-Redundancy Page Eight Frame Tribus System Non-Redundant Page Debug Information Uploading Debug Information Status window appears To find the file you just created, do the following Navigate to C\Telex\AZedit\DebugPage Installation To install the Tribus into an Adam frame, do the followingRequirements Configuration Intercom Configuration window appears Click Intercom Sizing Wizard Select the The number of frames in the intercom radio buttonSelect the Enable Test Audio recommended check box Intercom Configuration window reappears Click the Frame 2 IP Address 1 field Click the browse buttonBase 8 vs. Base 16 Port Number Systems Base 8 Port Number SystemPage Base 16 Port Number System Base 16 Port Numbering System ExampleForce Autonomous Mode Check Box AZedit Connections Connect To Frame MenuFrame Mapping Table Window Frame ColumnIP Address 2 Column IP Address 1 ColumnMAC Address 1 Column MAC Address 2 ColumnMove Down Button Base 16 Column Check BoxMove Up Button Accept Frame Mapping Table from Other Frames Check BoxSelect Frame Window Test ButtonDone Button Cancel Button OK ButtonTBX Links Status Window TBX ColumnComm Column Link Up/Dn Column Partner ColumnAudio B Column Intercom AlarmsAudio a Column Audio C ColumnTo open the Intercom Alarms window, do the following Intercom Alarms WindowAlarm Time Column Resolved Time ColumnDescription Column Configure Logging Window Logging WindowJ10 Radio Button J1 Radio ButtonJ9 Radio Button Ethernet Radio ButtonDownload Firmware Upgrades Download Firmware to the TBX-Tribus CardFirmware Download window appears Click Begin DownloadVerify the Tribus card firmware has been updated Successful Download Message Click OK