RTS ADAM manual Base 16 Column Check Box, Move Up Button, Move Down Button, Apply Button

Page 35

Base 16 Column Check Box

The Base 16 check box is used to enable the Base 16 port number system. For more information, see “Base 8 vs. Base 16 Port Number Systems” on page 24.

Move Up Button

The Move Up button allows you to set the frame position of the system up in the Frame hierarchy. Frame 1 is the master frame and holds the most complete frame mapping table. If frame 1 fails, then frame 2 becomes the master frame,

Move Down Button

The Move Down button allows you to set the frame position of the system down in the Frame hierarchy. Frame 1 is the master frame and holds the most complete frame mapping table. If frame 1 fails, then frame 2 becomes the master frame,

Accept Frame Mapping Table from Other Frames Check Box

The Accept Frame Mapping Table from Other Frames check box is used to allow other frames to send their frame mapping information to the selected frame.

NOTE: Each frame in a valid system must be defined in a table map to be able to communicate with the other frames in the system.

Apply Button

The Apply button is used to accept the modifications you make and send them to the Intercom System. Once the modifications have been applied, AZedit displays the message below and then reboots itself.

FIGURE 44. Apply Button message

NOTE: You must press the Test button before the Apply button becomes active.

31

Image 35

Contents Adam See the enclosed warranty card for further details Contents Page Figures Page Version Requirements General DescriptionInterface with Adam FeaturesBoard Performance SpecificationsConfiguration Requirements Fail-Over Modes Full Redundancy Partial Redundancy Non-Redundancy Page Eight Frame Tribus System Non-Redundant Page Debug Information Uploading Debug Information Status window appears Navigate to C\Telex\AZedit\Debug To find the file you just created, do the followingPage Requirements InstallationTo install the Tribus into an Adam frame, do the following Configuration Intercom Configuration window appears Select the The number of frames in the intercom radio button Click Intercom Sizing WizardSelect the Enable Test Audio recommended check box Intercom Configuration window reappears Click the browse button Click the Frame 2 IP Address 1 fieldBase 8 Port Number System Base 8 vs. Base 16 Port Number SystemsPage Base 16 Port Numbering System Example Base 16 Port Number SystemForce Autonomous Mode Check Box Connect To Frame Menu AZedit ConnectionsFrame Column Frame Mapping Table WindowMAC Address 2 Column IP Address 1 ColumnMAC Address 1 Column IP Address 2 ColumnAccept Frame Mapping Table from Other Frames Check Box Base 16 Column Check BoxMove Up Button Move Down ButtonDone Button Select Frame WindowTest Button OK Button Cancel ButtonComm Column TBX Links Status WindowTBX Column Partner Column Link Up/Dn ColumnAudio C Column Intercom AlarmsAudio a Column Audio B ColumnIntercom Alarms Window To open the Intercom Alarms window, do the followingDescription Column Alarm Time ColumnResolved Time Column Logging Window Configure Logging WindowEthernet Radio Button J1 Radio ButtonJ9 Radio Button J10 Radio ButtonDownload Firmware to the TBX-Tribus Card Download Firmware UpgradesClick Begin Download Firmware Download window appearsSuccessful Download Message Click OK Verify the Tribus card firmware has been updated