RTS ADAM manual Base 8 vs. Base 16 Port Number Systems, Base 8 Port Number System

Page 28

Base 8 vs. Base 16 Port Number Systems

With the advent of the TBX-Tribus card and the ever evolving technology to a 16-channel port system, Base 8 and Base 16 port number systems were created.

Base 8 Port Number System

The Base 8 Port Number System splits 16 ports between a top and bottom group. The bottom group starts with 1 through 136; the top group consists of ports 137 through 272 (see Figure 37).

EXAMPLE: This means that if you have an AIO-16 in slot 1, ports 1–8 and 137–144 will be used by the AIO-16 card. Alternatively, if you have AIO-16’s in slots 1 and 3 and an AIO-8 in slot 2, the following port mapping applies:

Figure 3. Example for Base 8 Port Numbering

AIO-16 Ports 1– 8 and 137–144

Ports 145-161 are not used when an AIO-8 card is in the slot AIO–8 Ports 9–16

AIO-6 Ports 17–33 and 162–178

FIGURE 37. Base 8 Port Numbering System Example

24

Image 28
Contents Adam See the enclosed warranty card for further details Contents Page Figures Page General Description Version RequirementsFeatures Interface with AdamConfiguration Requirements SpecificationsBoard Performance Fail-Over Modes Full Redundancy Partial Redundancy Non-Redundancy Page Eight Frame Tribus System Non-Redundant Page Debug Information Uploading Debug Information Status window appears To find the file you just created, do the following Navigate to C\Telex\AZedit\DebugPage To install the Tribus into an Adam frame, do the following InstallationRequirements Configuration Intercom Configuration window appears Click Intercom Sizing Wizard Select the The number of frames in the intercom radio button Select the Enable Test Audio recommended check box Intercom Configuration window reappears Click the Frame 2 IP Address 1 field Click the browse buttonBase 8 vs. Base 16 Port Number Systems Base 8 Port Number SystemPage Base 16 Port Number System Base 16 Port Numbering System ExampleForce Autonomous Mode Check Box AZedit Connections Connect To Frame MenuFrame Mapping Table Window Frame ColumnIP Address 1 Column MAC Address 1 ColumnIP Address 2 Column MAC Address 2 ColumnBase 16 Column Check Box Move Up ButtonMove Down Button Accept Frame Mapping Table from Other Frames Check BoxTest Button Select Frame WindowDone Button Cancel Button OK ButtonTBX Column TBX Links Status WindowComm Column Link Up/Dn Column Partner ColumnIntercom Alarms Audio a ColumnAudio B Column Audio C ColumnTo open the Intercom Alarms window, do the following Intercom Alarms WindowResolved Time Column Alarm Time ColumnDescription Column Configure Logging Window Logging WindowJ1 Radio Button J9 Radio ButtonJ10 Radio Button Ethernet Radio ButtonDownload Firmware Upgrades Download Firmware to the TBX-Tribus CardFirmware Download window appears Click Begin DownloadVerify the Tribus card firmware has been updated Successful Download Message Click OK