RTS ADAM manual AZedit Connections, Connect To Frame Menu

Page 32

3.Click the Options tab. The Options page appears.

4.Select the Force Autonomous Mode when no audio links up check box. Force Autonomous Mode is activated.

5.Click Apply.

The Intercom Configuration window closes.

AZedit Connections

The AZedit Connections menu item, shown in Figure 41, is used to select a frame to which AZedit connects. This menu also has the option to Auto Connect. If this is selected, AZedit automatically tries to connect to another frame if it loses its connection to the current frame.

NOTE: This menu is only available when AZedit is configured to communicate using Ethernet.

TIP: You can also change the frame, the serial port, or IP Address in the Communications window (OptionsCommunications).

FIGURE 41. Connect To Frame Menu

28

Image 32
Contents Adam See the enclosed warranty card for further details Contents Page Figures Page General Description Version RequirementsFeatures Interface with AdamBoard Performance SpecificationsConfiguration Requirements Fail-Over Modes Full Redundancy Partial Redundancy Non-Redundancy Page Eight Frame Tribus System Non-Redundant Page Debug Information Uploading Debug Information Status window appears To find the file you just created, do the following Navigate to C\Telex\AZedit\DebugPage Requirements InstallationTo install the Tribus into an Adam frame, do the following Configuration Intercom Configuration window appears Click Intercom Sizing Wizard Select the The number of frames in the intercom radio buttonSelect the Enable Test Audio recommended check box Intercom Configuration window reappears Click the Frame 2 IP Address 1 field Click the browse buttonBase 8 vs. Base 16 Port Number Systems Base 8 Port Number SystemPage Base 16 Port Number System Base 16 Port Numbering System ExampleForce Autonomous Mode Check Box AZedit Connections Connect To Frame MenuFrame Mapping Table Window Frame ColumnIP Address 1 Column MAC Address 1 ColumnIP Address 2 Column MAC Address 2 ColumnBase 16 Column Check Box Move Up ButtonMove Down Button Accept Frame Mapping Table from Other Frames Check BoxDone Button Select Frame WindowTest Button Cancel Button OK ButtonComm Column TBX Links Status WindowTBX Column Link Up/Dn Column Partner ColumnIntercom Alarms Audio a ColumnAudio B Column Audio C ColumnTo open the Intercom Alarms window, do the following Intercom Alarms WindowDescription Column Alarm Time ColumnResolved Time Column Configure Logging Window Logging WindowJ1 Radio Button J9 Radio ButtonJ10 Radio Button Ethernet Radio ButtonDownload Firmware Upgrades Download Firmware to the TBX-Tribus CardFirmware Download window appears Click Begin DownloadVerify the Tribus card firmware has been updated Successful Download Message Click OK