RTS ADAM Successful Download Message Click OK, Verify the Tribus card firmware has been updated

Page 47

FIGURE 55. Successful Download Message

9.Click OK.

The success message and Download Device Firmware window closes.

10.From the Status menu, select I/O Cards. The IO Card Status window appears.

11.Verify the Tribus card firmware has been updated.

CAUTION:Do not power down the frame or remove the TBX-Tribus card from the frame until you have verified the new version information from AZedit. If the card loses power during download, undesirable results may occur.

43

Image 47

Contents Adam See the enclosed warranty card for further details Contents Page Figures Page Version Requirements General DescriptionInterface with Adam FeaturesBoard Performance SpecificationsConfiguration Requirements Fail-Over Modes Full Redundancy Partial Redundancy Non-Redundancy Page Eight Frame Tribus System Non-Redundant Page Debug Information Uploading Debug Information Status window appears Navigate to C\Telex\AZedit\Debug To find the file you just created, do the followingPage Requirements InstallationTo install the Tribus into an Adam frame, do the following Configuration Intercom Configuration window appears Select the The number of frames in the intercom radio button Click Intercom Sizing WizardSelect the Enable Test Audio recommended check box Intercom Configuration window reappears Click the browse button Click the Frame 2 IP Address 1 fieldBase 8 Port Number System Base 8 vs. Base 16 Port Number SystemsPage Base 16 Port Numbering System Example Base 16 Port Number SystemForce Autonomous Mode Check Box Connect To Frame Menu AZedit ConnectionsFrame Column Frame Mapping Table WindowMAC Address 2 Column IP Address 1 ColumnMAC Address 1 Column IP Address 2 ColumnAccept Frame Mapping Table from Other Frames Check Box Base 16 Column Check BoxMove Up Button Move Down ButtonDone Button Select Frame WindowTest Button OK Button Cancel ButtonComm Column TBX Links Status WindowTBX Column Partner Column Link Up/Dn ColumnAudio C Column Intercom AlarmsAudio a Column Audio B ColumnIntercom Alarms Window To open the Intercom Alarms window, do the followingDescription Column Alarm Time ColumnResolved Time Column Logging Window Configure Logging WindowEthernet Radio Button J1 Radio ButtonJ9 Radio Button J10 Radio ButtonDownload Firmware to the TBX-Tribus Card Download Firmware UpgradesClick Begin Download Firmware Download window appearsSuccessful Download Message Click OK Verify the Tribus card firmware has been updated