RTS ADAM manual Select Frame Window, Test Button, Done Button

Page 36

Test Button

The Test button is used to test the frame mapping configuration you create. Once you have tested your frame map configuration, press the Apply button to implement the modifications you make. The message below appears if the frame map is deemed valid.

FIGURE 45. Frame Mapping Table Valid message

Done Button

The Done button is used to close the Frame Mapping window.

Select Frame Window

The Select Frame window, shown in Figure 46, is used to select a Frame (IP Address and MAC Address) to include in the Frame Mapping table for your Tribus Intercom System.

FIGURE 46. Select Frame Window

IP Address 1 Column

The IP Address 1 column displays the IP Address of the active master controller in the ADAM frame.

32

Image 36

Contents Adam See the enclosed warranty card for further details Contents Page Figures Page General Description Version RequirementsFeatures Interface with AdamSpecifications Configuration RequirementsBoard Performance Fail-Over Modes Full Redundancy Partial Redundancy Non-Redundancy Page Eight Frame Tribus System Non-Redundant Page Debug Information Uploading Debug Information Status window appears To find the file you just created, do the following Navigate to C\Telex\AZedit\DebugPage Installation To install the Tribus into an Adam frame, do the followingRequirements Configuration Intercom Configuration window appears Click Intercom Sizing Wizard Select the The number of frames in the intercom radio buttonSelect the Enable Test Audio recommended check box Intercom Configuration window reappears Click the Frame 2 IP Address 1 field Click the browse buttonBase 8 vs. Base 16 Port Number Systems Base 8 Port Number SystemPage Base 16 Port Number System Base 16 Port Numbering System ExampleForce Autonomous Mode Check Box AZedit Connections Connect To Frame MenuFrame Mapping Table Window Frame ColumnIP Address 1 Column MAC Address 1 ColumnIP Address 2 Column MAC Address 2 ColumnBase 16 Column Check Box Move Up ButtonMove Down Button Accept Frame Mapping Table from Other Frames Check BoxSelect Frame Window Test ButtonDone Button Cancel Button OK ButtonTBX Links Status Window TBX ColumnComm Column Link Up/Dn Column Partner ColumnIntercom Alarms Audio a ColumnAudio B Column Audio C ColumnTo open the Intercom Alarms window, do the following Intercom Alarms WindowAlarm Time Column Resolved Time ColumnDescription Column Configure Logging Window Logging WindowJ1 Radio Button J9 Radio ButtonJ10 Radio Button Ethernet Radio ButtonDownload Firmware Upgrades Download Firmware to the TBX-Tribus CardFirmware Download window appears Click Begin DownloadVerify the Tribus card firmware has been updated Successful Download Message Click OK