Optiquest iRIS 220 manual Technical Specifications iRIS 320 / iRIS

Page 11

9 - iRIS 220 / iRIS 320, V1.19 User Guide

2.7 Technical Specifications – iRIS 320 / iRIS 320V

Dimensions:

117mm x 162mm x 67mm (4.60in x 6.37in x 2.64in)

 

(Excluding glands and mounting plate)

Mass:

1580g (3.48lb)

Power Supply:

Internal 12V @ 0.8A/Hr rechargeable sealed lead acid battery. Can also connect

 

external regulated 12V dc power supply or rechargeable sealed lead-acid battery.

Charger Supply:

External 15-30Vdc supply. Supports a directly connected solar panel (no regulator).

Power Consumption:

Less than 3mA @ 12V in idle mode. Actual current consumption is dependent on

 

power management mode, wireless modem state and I/O configuration.

Comms Interfaces:

1x RS232 DB9, 38,400 bps, DTE configuration.

 

1x Integral dual-band (900/1800MHz) GSM/GPRS modem or

 

Integral single-band (1900MHz) GSM/GPRS modem or

 

Integral CDMA/CDMA-1X modem.

Digital I/O:

2 x Digital Inputs

 

- 30Vdc maximum input, switch to 0Vdc to activate.

 

- Link selectable for either mechanical (<20Hz) or electronic (<5kHz) switching.

2 x Digital Outputs

-1 x Switched 12V out (max 300mA)

-1 x Open-drain pull-down (max 300mA @ 30V)

Analog I/O:4 x 12 bit uni-polar Analog inputs. Range 0-5000mV. Input impedance 98k￿. Referenced to 0V common. Internal measurements available for monitoring are:

Battery Voltage

Supply Voltage

Internal Temperature (°C or °F)

Received Signal Strength (RSSI)

SDI-12 Interface: SDI-12 hardware interface that fully complies with the SDI-12 electrical standard. Software support to SDI-12 standard 1.2.

Logging Memory: Non-volatile 2MB flash storage of 262,144 time/date stamped data points. Circular buffer mode (overwrites oldest data when memory full).

A typical site with 2 parameters logged every 15 minutes plus battery voltage logged hourly will give 3.3 years of storage before data overwrite occurs.

Audio Memory: iRIS 320V only. Non-volatile 2MB flash storage of PCM audio files. Total cumulative playtime 3 minutes at 11.025kHz sampling rate.

Clock/Calendar: Non-volatile with integral lithium back-up battery. Y2K compliant with leap year recognition. Accurate to +/-20 secs month, trimmable via a configuration register.

Mounting:4 x M4 (3/16”) blind mounting holes in rear of case. Mounting plate supplied as standard accessory for wall or panel installation.

2 x 16mm (¾”) compression glands for power supply and I/O cabling access.

1 x 25mm (1”) compression gland for antenna / RF cable access

Front secured by three M5 Allen Key® screws. The two(left-hand) screws act as hinge links. The third (right-hand) screw can be locked with a tamper-proof wire seal.

Environmental: Storage Temperature: -20°C - +85°C. (-4°F - +185°F)

Operating Temperature: -10°C - +70°C. (14°F - +158°F)

Enclosure sealed to IP65 with gasket and glands.

Image 11
Contents IRIS 220 iRIS Revision History Contents Diagnostic LEDs 13.4 13.113.2 13.3Support IntroductionAbout this Manual Hardware PCB RevisionIntroduction General Characteristics iRISOverview IRIS 320 / iRIS Typical Applications FeaturesFeature Summary Technical Specifications iRIS Technical Specifications iRIS 320 / iRIS Alternative Wireless Connectivity CSD/SMS Key FeaturesTerminal Configuration Wireless IP Connectivity GPRS/CDMAData Logging Partial Power SaveFull Power Save Security Alarm ProcessingLogged Data Array Identification Real Time Clock & CalendarRemoving / fitting the SIM card GSM models only InstallationRemoving/Replacing the Electronic Assembly iRIS Opening / Closing the Housing iRIS 320 / iRISInternal Battery iRIS 320 / iRIS 320V only I/O ConnectorAnalog Inputs Internal / External 12V Battery SupplyExternal Charger Power Supply Digital Input Circuit Digital InputsDigital Output 1 Circuit Digital OutputsMounting iRIS Antenna ConnectionMounting iRIS 320 / iRIS IRIS 320 / iRIS 320V Mounting DiagramComputer IRIS ConfigurationTerminal Connection Terminal Cfg IRIS 220 / iRIS 320, V1.19 User Guide Main Menu Level Terminal MenusSelect this option to display the Comms configuration menu Comms Cfg Level Option 9 SDI-12 Terminal iRIS 320 / iRIS 320V only Press Esc then Enter to enter an empty string GPRS/CDMA-1X Cfg LevelGprs IP Acceptance Cfg Level Phone List LevelGPRS/CDMA-1X Schedule Cfg Level Sensor Selection Level Internal Sensor Sources Log Multiplier 100 100 Sensor Cfg LevelSupplementary Logging Flag Definitions Mode Name DescriptionFlag Value Description Multiplier= Alarm Cfg Level Alarm Selection LevelOutput Cfg Level Output Selection LevelSource 0 1 2 3 4 Description Typical Scheduled Output Example Date/Time Cfg LevelMiscellaneous Menu Level Voice Menu Level Status LED LED IndicatorsDiagnostic LEDs OperationKeypad Buttons LCD & Keypad iRIS 320 onlyLCD Operation Status IconsLevel Level6 Display Menu StructureSystem Status 1 Screen Level Log In Screen Level 0, when not loggedLogging Control Screen Level 0, when logged Primary LCD Display ScreensMain Menu Screen Level Sensor Related ScreensSystem Status 3 Screen Level System Status 4 Screen LevelSensor Settings Screen 4/5 Alarm 1 Level Sensor Settings Screen 1/5 Process LevelSensor Settings Screen 2/5 Scaling Level Sensor Settings Screen 3/5 Logging LevelTotaliser Related Screens Comms Related Screens Comms Setting Screen 5/8 Schedule 1 Level Comms Setting Screen 2/8 APN/Local IP LevelComms Setting Screen 3/8 Socket a Level Comms Setting Screen 4/8 Socket B LevelRS232 Port Mode Screen Level Comms Setting Screen 6/8 Schedule 2 LevelComms Setting Screen 7/8- CSD Settings Level Comms Setting Screen 8/8 RS232 Settings LevelComms Test Screen Level Comms Enable Screen LevelSMS Communication General Hints Sensor Connection Examples Connecting a Flow Meter or Rain GaugeIris I/O Connector Required Connecting a 0-5V Pressure Transducer12V Battery ExternalSignal 4-20mA Sensor Isolated 12V 24V DC- DC Converter Connecting a 2-Wire Loop-Powered 4-20mA SensorRequired IRIS I/O Connector External 12V Battery Optional Connecting an Up/Down Water Level InstrumentConnecting Analogue Wind Instruments Charging source Solar panel Connecting SDI-12 Instruments. iRIS 320 / iRIS 320V onlyTOP AI4 AI3 AI2 AI1 Agnd 5VOP Example a 4-20mA Water Level Sensor Analogue Input ScalingTroubleshooting User Notes DS-IRM Modem DB25 M Appendix a Radio Using the RS232 InterfaceTait TM80xx Radio DB15 MiRIS 3xx / DS-4483 DB9 F IRIS 320 DB9 FPartition Appendix B Voice Annunciation iRISAdvantages of SDI-12 What is SDI-12?Appendix C SDI-12 iRIS 320 / 320V only Volt-Line SDI-12 Electrical InterfaceSerial Data Line Ground LineDebounce Links 13.1 I/O ConnectorAppendix D Legacy PCB Rev 1.1 Details SDI-12 Interface Diagnostic LEDsInterface Wire Terminal SDI-12 Bus Function REDSupply Voltage Transistor SwitchPurple Switched Output Switch ModuleChemical Composition Appendix E iRIS 320 Enclosure Material SpecApproximate Mechanical Properties IQuest Global Data Network IQuest APN