iRIS 220 / iRIS 320, V1.19 User Guide - 4
1 Introduction
1.1 About this Manual
This manual is intended as a detailed guide for iRIS 200 / iRIS 320 installation, configuration and operation. For a brief operational overview, see the separate iRIS 220 Installation Guide or iRIS 320 Installation Guide.
This manual is also available online in Adobe Acrobat® pdf format for registered users atwww.iquest.co.nz
NOTE: The term “iRIS” is used throughout this manual equally applicable to either the iRIS 220 or the iRIS 320. one of the models, the full model reference will be used.
in all inst ances where the reference is When a particular section applies to only
NOTE: The term
1.2 Hardware (PCB) Revision
As from firmware version 2.19 / software version 1.19, this manual has been completely updated to refer to the new version PCB (V1.2). This hardware revision has the following changes over its predecessor:
∙Two additional analogue inputs added.
∙Dedicated 5V reference output for energising potentiometer type sensors.
∙Digital Output 1 changed to a switched 12V output instead of
∙
Legacy I/O and
1.3 Support
Technical support for the iRIS 220 and iRIS 320 is available by contacting:
iQuest (NZ) Ltd
P.O Box 15169
Hamilton
NEW ZEALAND
Tel: | +64 7 |
Fax: | +64 7 |
Email: | support@iquest.co.nz |
For latest information and software updates, visit the iQuest (NZ) Ltd web site at www.iquest.co.nz
4 | iQuest (NZ) Ltd - PO Box 15169, Hamilton, New Zealand Tel: +64 7 |