SUPER
HD LED Indicator (JF2)
The HD LED connector located at JF2 is used to indicate activity on any hard drive (IDE, SCSI or CD- ROM).
Power LED (JF2)
The Power LED connection located at JF2 is used to inform you that power is being supplied to the motherboard. There is also an onboard LED for this function (see CR5 in Section
Speaker (X5DL8-GG)
Aspeaker header/jumper is lo- cated on JF2. You may enable the onboard speaker by jumping pins 13 & 15 of JF2. To use an exter- nal speaker, connect the speaker header to pins 9 through 15.
Third Power Supply Fail Header
Connect a cable from your power supply to the JP46 header to pro- vide warning of power supply fail- ure. The warning signal is passed through the PWR_LED pin on JF1 to provide indication of a power failure on the chassis. Note: This feature is only available when us- ing Supermicro power supplies. See the table on the right for pin definitions.
Third Power Supply Fail Header
Pin Definitions (JP46)
Pin |
|
Number | Definition |
1 | P/S 1 Fail Signal |
2 | P/S 2 Fail Signal |
3 | P/S 3 Fail Signal |
4 | Reset (from MB) |
|
|