Chapter 2: Installation
Main Power Override (X5DL8-GG)
Instead of using the chassis power on switch, you may close jumper JP7 to apply power to the system. This effectively disables the power button from turning off the system. See the table on the right for jumper settings. The de- fault setting is Open (normal).
Power On
Jumper Settings
(JP1)
Jumper |
|
Position | Definition |
Open | Normal |
Closed | Force Power On |
|
|
2-9 Parallel Port, Floppy/Hard Disk Drive and SCSI Connections
Note the following when connecting the floppy and hard disk drive cables:
•The floppy disk drive cable has seven twisted wires.
•A red mark on a wire typically designates the location of pin 1.
•A single floppy disk drive ribbon cable has 34 wires and two connectors to provide for two floppy disk drives. The connector with twisted wires always connects to drive A, and the connector that does not have twisted wires always connects to drive B.
Parallel Port Connector
The parallel port is located on J65. See the table below right for pin definitions.
Parallel (Printer) Port Pin Definitions
(J65)
Pin Number | Function | Pin Number | Function |
1 | Strobe- | 2 | Auto Feed- |
3 | Data Bit 0 | 4 | Error- |
5 | Data Bit 1 | 6 | Init- |
7 | Data Bit 2 | 8 | SLCT IN- |
9 | Data Bit 3 | 10 | GND |
11 | Data Bit 4 | 12 | GND |
13 | Data Bit 5 | 14 | GND |
15 | Data Bit 6 | 16 | GND |
17 | Data Bit 7 | 18 | GND |
19 | ACK | 20 | GND |
21 | BUSY | 22 | GND |
23 | PE | 24 | GND |
25 | SLCT | 26 | NC |
|
|
|
|