SUPER MICRO Computer SUPER X5DLR-8G2+, SUPER X5DL8-GG user manual 60h

SUPER X5DL8-GG/X5DLR-8G2+/X5DLR-8G2 User’s Manual

Checkpoint	Code Description
60h	The DMA page register test passed. Performing the DMA Controller
	1 base register test next.
62h	The DMA controller 1 base register test passed. Performing the DMA
	controller 2 base register test next.
65h	The DMA controller 2 base register test passed. Programming DMA
	controllers 1 and 2 next.
66h	Completed programming DMA controllers 1 and 2. Initializing the 8259
	interrupt controller next.
67h	Completed 8259 interrupt controller initialization.
7Fh	Extended NMI source enabling is in progress.
80h	The keyboard test has started. Clearing the output buffer and
	checking for stuck keys. Issuing the keyboard reset command next.
81h	A keyboard reset error or stuck key was found. Issuing the keyboard
	controller interface test command next.
82h	The keyboard controller interface test completed. Writing the com-
	mand byte and initializing the circular buffer next.
83h	The command byte was written and global data initialization has
	completed. Checking for a locked key next.
84h	Locked key checking is over. Checking for a memory size mismatch
	with CMOS RAM data next.
85h	The memory size check is done. Displaying a soft error and checking
	for a password or bypassing WINBIOS Setup next.
86h	The password was checked. Performing any required programming
	before WINBIOS Setup next.
87h	The programming before WINBIOS Setup has completed.
	Uncompressing the WINBIOS Setup code and executing the
	AMIBIOS Setup or WINBIOS Setup utility next.
88h	Returned from WINBIOS Setup and cleared the screen. Performing
	any necessary programming after WINBIOS Setup next.
89h	The programming after WINBIOS Setup has completed. Displaying the
	power on screen message next.
8Bh	The first screen message has been displayed. The <WAIT...>
	message is displayed. Performing the PS/2 mouse check and
	extended BIOS data area allocation check next.
8Ch	Programming the WINBIOS Setup options next.
8Dh	The WINBIOS Setup options are programmed. Resetting the hard disk
	controller next.
8Fh	The hard disk controller has been reset. Configuring the floppy drive
	controller next.
91h	The floppy drive controller has been configured. Configuring the hard
	disk drive controller next.

B-6