![](/images/new-backgrounds/1186973/18697385x1.webp)
Chapter 2: Installation
PCI-X Bus Speed Setting (X5DL8-GG)
Jumpers P1, P2, S1 and S2 are used to change the speeds for the four
S1: Bus for
P1: Bus for
S2: Bus for
P2: Bus for
Note: If two cards are used in slots that share a bus, both slots will run at 100 MHz (maximum).
PCI-X Bus Speed Setting (X5DLR-8G2+, X5DLR-8G2)
Jumper P2 is used to change the speed of the single
Note: The
33 MHz PCI Enable/Disable (X5DL8-GG)
If you wish to use 33 MHz PCI cards, close J29 to force the P1 bus (slots 2 & 3) to run at 33 MHz. See the table on the right for jumper settings.
Note: if you force the slots(s) to 33 MHz, you must set the P1 bus speed jumpers (above) to the low- est speed.
Pin Definitions
(P1, P2, S1, S2)
Pin |
|
Setting | Speed |
Pins | PCI 33/66 MHz |
Pins | |
Pins | |
Pins | |
|
|
Default setting is PCI-X 100 MHz for all
slots.
Pin Definitions
(P2)
Pin |
|
Setting | Speed |
Pins | PCI 33/66 MHz |
Pins | |
Pins | |
Pins | |
|
|
This slot was designed for use with
in the slot.
33 MHz PCI
Enable/Disable
Jumper Settings
(J29)
Jumper |
|
Position | Definition |
Open | Normal |
Closed | 33 MHz PCI |
|
|