Western Telematic IPS-15 manual Quick Start, Hardware Installation

Page 11

3. Quick Start

This Quick Start procedure is included primarily to provide a quick demonstration of IPS capabilities. In order to take full advantage of the complete range of features provided by this unit, it is strongly recommended that you should complete the Installation and Configuration sections after completing the Quick Start procedure.

3.1. Hardware Installation

Make the following connections as described in Figure 3.1.

1.Switched AC Outlet: Connect the power cable from the switched device to the Switched AC outlet on the back panel of the IPS Master Unit.

2.Power Inlet: Connect the supplied power cable to the Power Inlet on the back panel of the IPS Master Unit. Connect the other end of the power cable to an appropriate power supply.

CAUTION: Make certain to review the safety precautions listed in Section 4.1.

3.10BaseT (Network) Port: Connect your 10Base-T or 100Base-T network interface to the IPS Network Port. For more information, please refer to Section 4.4.

Note: The IPS features a 10Base-T Interface. When connecting to a 100Base-T interface, most router switches will autosense to determine if the device is 100Base-T or 10Base-T, and then configure the network interface accordingly. If your router switch does not autosense, the network interface port must be manually set to 10Base-T.

4.Network Cable: Your 10Base-T or 100Base-T network interface.

3-1

Image 11

Contents WTIPartNo.13301Rev.B Page Table of Contents List of Figures IPSInternetPowerSwitchUsersGuideIntroduction Intelligent Power ControlTypographic Conventions Easy to Configure, Easy to UseMaster Unit Front Panel Unit DescriptionMaster Main Unit IPS-15 Master Unit Back Panel Master Unit Back PanelSatellite Unit Front Panel Optional Satellite UnitIPS-15 Satellite Unit Back Panel Satellite Unit Back PanelQuick Start Hardware InstallationConnections Diagram For Optional Satellite Units Only QuickStartWeb Browser Interface Communicating with the IPS-15QuickStart Text Interface $ telnet 192.168.168.168 Enter IPSInternetPowerSwitchUsersGuide Connection to Switched Outlets InstallationPower Supply Connection Console Port Connection Connecting the Network CableConnecting a Local PC Connecting an External ModemConnecting Optional IPS Satellite Units InstallationIPSInternetPowerSwitchUsersGuide System Mode and User Mode ConfigurationCommunicating with the IPS Accessing the Web Browser InterfaceAccessing the Text Interface ConfigurationPlug Status Screen Text Interface General Parameters Menus Configuration MenusGeneral Parameters Menu Web Browser Interface 9InactivityTimeout5. ConfirmationMin IPSInternetPowerSwitchUsersGuide Plug Parameters Menu Text Interface Plug Parameters MenusNetwork Parameters Menus Network Parameters Menu Text Interface IP Security Feature Telnet Parameters Menus Permit11 Telnet Parameters Menu Text Interface Web Server Parameters Menus13 Web Browser Parameters Menu Text Interface Save Configuration Parameters Plug Numbers and Plug Zones OperationPlug Status Screen Web Browser Interface Operation via the Web Browser InterfaceOperation Plug Status Screen Text Interface Boot/On/Off Commands Text InterfaceOperation via the Text Interface Boot 1 or /BO Atmswtch Applying Commands to Several Plugs Text Interface Logging Out of Command ModeAutomated Mode Manual Operation Sending Parameters to a File Saving and Restoring Configuration ParametersRestoring Saved Parameters Console Port Interface Straight Wired RJ11 CablesInterface Descriptions Ordering Information SpecificationsApx-3 Customer ServiceTrademark and Copyright Information Apx-4464 Index1to5 BudRateCables NetwrkPortAccess 3-1,.534-2,5-5124