Western Telematic IPS-15 manual IPSInternetPowerSwitchUsersGuide

Page 22

IPSInternetPowerSwitch;User'sGuide

c)When addresses are assigned to a series of IPS Satellite Units, all satellites that share a specific address (for example "2"), are considered to be part of the same "Zone." For example, if your application includes three satellite units whose Address Selector Switches are set at "2", then those three Satellite units would all be part of "Zone 2", and any commands directed to Zone 2 would be applied to those three satellite units.

d)For more information on Satellite Addresses and Zones, please refer to Section 6.1.

Notes:

￿The Master Unit will not recognize Satellite Units that are connected while the Master Unit is powered up, until the Master Unit has been powered off and on.

￿If you attempt to address a command to a Satellite Unit that was connected after Power Up, the IPS-15 Plug Status Screen will indicate that the Satellite Unit is not recognized.

￿After connecting Satellite Units to the IPS-15 Master Unit, use the Master Power Switch on the Master Unit's back panel to power the Master Unit Off, and then Back on again. This will allow the Master Unit to recognize all newly connected Satellite units.

This completes the IPS-15 installation instructions. Please proceed to the next Section for instructions regarding unit configuration.

4-4

Image 22
Contents WTIPartNo.13301Rev.B Page Table of Contents IPSInternetPowerSwitchUsersGuide List of FiguresIntelligent Power Control IntroductionEasy to Configure, Easy to Use Typographic ConventionsMaster Main Unit Unit DescriptionMaster Unit Front Panel Master Unit Back Panel IPS-15 Master Unit Back PanelOptional Satellite Unit Satellite Unit Front PanelSatellite Unit Back Panel IPS-15 Satellite Unit Back PanelHardware Installation Quick StartConnections Diagram QuickStart For Optional Satellite Units OnlyCommunicating with the IPS-15 Web Browser InterfaceQuickStart Text Interface $ telnet 192.168.168.168 Enter IPSInternetPowerSwitchUsersGuide Power Supply Connection InstallationConnection to Switched Outlets Connecting an External Modem Connecting the Network CableConnecting a Local PC Console Port ConnectionInstallation Connecting Optional IPS Satellite UnitsIPSInternetPowerSwitchUsersGuide Configuration System Mode and User ModeAccessing the Web Browser Interface Communicating with the IPSConfiguration Accessing the Text InterfacePlug Status Screen Text Interface Configuration Menus General Parameters MenusGeneral Parameters Menu Web Browser Interface 9InactivityTimeout5. ConfirmationMin IPSInternetPowerSwitchUsersGuide Plug Parameters Menus Plug Parameters Menu Text InterfaceNetwork Parameters Menus Network Parameters Menu Text Interface IP Security Feature Permit Telnet Parameters MenusWeb Server Parameters Menus 11 Telnet Parameters Menu Text Interface13 Web Browser Parameters Menu Text Interface Save Configuration Parameters Operation Plug Numbers and Plug ZonesOperation via the Web Browser Interface Plug Status Screen Web Browser InterfaceOperation Operation via the Text Interface Boot/On/Off Commands Text InterfacePlug Status Screen Text Interface Boot 1 or /BO Atmswtch Logging Out of Command Mode Applying Commands to Several Plugs Text InterfaceAutomated Mode Manual Operation Saving and Restoring Configuration Parameters Sending Parameters to a FileRestoring Saved Parameters Interface Descriptions Straight Wired RJ11 CablesConsole Port Interface Specifications Ordering InformationCustomer Service Apx-3Apx-4 Trademark and Copyright InformationBudRate Index1to5 464NetwrkPortAccess 3-1,.534-2,5-5124 Cables